5
3D Adapter
Battery Installation
The remote control requires one CR2025 lithium battery.
1
2
Emitter
1.Remove the cover.
To remove the battery, press on the retaining clip.
2.Insert the battery, positive side up. Be sure the retaining clip holds the battery securely.
3.Reinstall the cover.
Lithium Battery Safety
This product uses CR2025 Li/MnO2 lithium coin batteries.
WARNING: Lithium coin cell batteries pose a serious risk of injury if ingested. Keep cells out of reach of children. If ingested immediately contact a physi- cian or the National Poison Center at
CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type (CR2025).
CAUTION: Risk of fire and burns. Do not recharge, disassemble, heat above 100˚ C (212˚ F), or incinerate. Keep battery out of reach of children. Disposal. Dispose of used batteries promptly according to local recycling or waste regulations.
Controls and Indicators
POWER | 3D STATUS |
IR Sensor
POWER 3D MODE
Adapter
POWER | 3D MODE |
Remote Control
POWER Light | Lit when power is on. |
|
|
3D STATUS Light | Lit during 3D signal processing. |
|
|
POWER Button | Allows manual override of auto on/off. Press to power |
| off the Adapter if it powers on when not needed, |
|
|
3D MODE Button | Allows manual selection of 3D format conversion. |
|
|
