DCP Operation

Control:

RemoveMakeBusy

F1 F2 F3

Press any function key to select RemoveMakeBusy. The message Command Complete appears on the LCD.

Service Line/Disconnect Service Line

The Service Line/Disconnect Service Line is only available in Models 3921-B1-001 and 3021-B1-011.

The Service Line function allows you to switch a specific Model 3921Plus installed in a COMSPHERE 3000 Series Carrier from normal leased or dial operation to service-line operation. This switch only places the modem on the service line. For a connection to be established, you must still use the normal dialing methods as described earlier in this chapter in the Call Setup Branch section.

A service line is an extra dial line connected to a COMSPHERE 3000 Series Carrier. This line is normally shared by up to four Model 3921Plus multiport or eight singleport modems installed in either Slots 1±8 or Slots 9±16. However, by daisy chaining the service-line connector of one Network Interface Module (NIM) to the service line of another NIM installed in the same carrier, you can permit eight multiport or sixteen singleport modems to share one service line. The service line can also be extended to other carriers in a cabinet. For more information on daisy chaining NIMs to the service line, refer to the COMSPHERE 3000 Series Carrier, Installation Manual.

A service line is ideal for a dial backup of Model 3921Plus modems operating on leased lines. Remember that a service line can back up only one failed leased line at a time.

To enable service line from the Control branch, make the following selections:

Press the

key until Service Line appears.

Control:

Service_Line

F1 F2 F3

Press F1 (Service_Line) to switch the modem from its normal dial line to the service line.

Service_Line

Command Complete

F1 F2 F3

The message Command Complete appears. Now, when the modem places a call, instead of using the dial, the call is placed on the service line.

3920-A2-GN31-30

November 1996

3-41

Page 78
Image 78
Paradyne 392xPLUS operation manual Service Line/Disconnect Service Line, Control RemoveMakeBusy, Control ServiceLine