DCP Operation

Select

DS Port

>

All

 

 

F1

F2

F3

To change the data stream on all ports again, press the F1 key.

or

To exit this function and remain in the Control branch, press the key. To exit and return to the

Top-Level menu, press the key.

EIA LEDs

This function allows the front panel EIA LEDs to display and change the activity of a selected digital interface. Use the EIA LEDs function to change the port that controls the front panel LED.

Based on the modem's configuration, the following conditions exist:

The CC or DC selection is not available if the Diagnostic Connector configuration option is disabled. Refer to the Diag Connection configuration option in the Misc section of Chapter 4.

The CC or DC interface is not available on the 3921Plus modem. The CC or DC activity is monitored on the SDU in the 3000 Series carrier.

Ports 3 or 4 are not available in the DTE Bridge mode.

Ports 2, 3, and 4 are available in TDM/MSD mode.

To access EIA LEDs from the Control branch, make the following selections:

Control:

EIA_LEDs

F1 F2 F3

Press the

key until EIA LEDs appears. Select EIA LEDs.

EIA LEDs:xxxxx >

Port1Port2

F1 F2 F3

The port field (xxxxx) displays the currently selected interface. Valid interface selections are Port1, Port2, Port3, Port4, and depending on the set value of the Diagnostic Connection configuration option, CC (NMS Control Channel), or DC (Diagnostic Channel). Refer to Diag Connection configuration option in the Misc section of Chapter 4.

3920-A2-GN31-30

November 1996

3-39

Page 76
Image 76
Paradyne 392xPLUS operation manual Select DS Port All, Control EIALEDs, EIA LEDsxxxxx Port1Port2