Paradyne 392xPLUS operation manual Top-Level Menu Status Message Indicates, Call Failure

COMSPHERE 392xPlus Modems

Table 3-3

(2 of 3)

Top-Level Menu Status

Status

Message

Indicates

Call Failure	Busy Signal	The answering modem is busy.
	Delayed	As a result of failed call attempts, this number can not be called at this time.
	Number {	Please try again later.
	Dial Line in Use	The modem is operating on dial networks when another call attempt is
		issued.
	Forbidden	As a result of failed call attempts, this number can not be called again.
	Number {
	Invalid Number	The modem has dialed a telephone number not stored in a directory
		location.
	Line Occupied{{	The line is being used by the associated telephone.
	No Answer Tone	The answering modem did not answer within the time limit specified by the
		No Answer Timeout configuration option. The network tones (if any) could
		not be interpreted by the modem.
	No Dial-DTR	The modem cannot dial because DTR is OFF.
	No Dial-Test	The modem cannot dial because it is running a Test.
	No Dial Tone	The modem has aborted the call because it cannot detect a dial tone.
	No Quiet Answer	The modem has detected No Quiet Answer (@) before the time-out setting
		of the No Answer Disconnect configuration option.
	Ringback	The answering modem did not answer within the time limit specified by the
	Timeout	No Answer Timeout configuration option. A ringback signal was detected.
	Trunk Busy	The modem is receiving a fast (trunk) busy.
	Wrong Call	The call was answered, but not by a modem. No answer tone.

{The Delayed Number and Forbidden Number messages appear only in countries where the number of repeat call attempts are restricted. The regulations vary in each country. If the number is delayed, the value of the delay (in minutes) can be displayed by entering Directory Status (see Call Setup Branch).

{{The Line Occupied message appears only in countries where the Offhook Detector is enabled. The purpose of the Offhook Detector is to detect whether the telephone associated with the modem is off-hook. It is enabled on a per country basis, and this setting can not be changed by a command. The Offhook Detector is enabled in Austria, Germany, and Switzerland.

3-12 November 1996 3920-A2-GN31-30