
COMSPHERE 392xPlus Modems
configuration, then you must change the factory setting using either the modem's DCP (as described in the following sections) or the AT command set.
The purpose of having preset configurations is so that you can have a ªhead startº in getting your modem operating and reducing the amount of time required to configure your modem. For a better understanding of DCP operation and factory preset configuration options, refer to Chapter 4, DCP Configuration.
Using the Diagnostic Control Panel (DCP)
The DCP's liquid crystal display (LCD) consists of two
To change a factory template from the Sync Leased preset configuration using the DCP, perform the following steps:
1.Press the function key below Configure to select the Configure branch. The LCD now displays Ld EditArea frm.
2.Press the key until Factory comes into view, then press the F1 key to display the factory preset configurations.
Factory preset configurations are Sync Leased, Async Leased, TMp (Trellis Multipoint), Async Dial, Sync Dial, and UNIX Dial. If Sync Leased or Async Leased is selected, you must choose either Answer or Originate mode. If TMp is selected, you must choose either Control or Trib (Tributary) mode.
3.Press the key until the appropriate factory preset appears on the LCD, and press the corresponding function key to select your choice. (For certain factory presets you will also need to choose the appropriate mode.)
4.Choose Function appears and displays the Edit and Save functions.
5.Press the F3 key (Save) to save the new factory preset configuration to one of three configuration areas, Active (Saved), Customer 1, or Customer 2.
(These three configuration areas are nonvolatile memory locations. Active (Saved) contains the most recently saved changes to any configuration options. In the event of power loss, the modem retrieves these configuration options. Customer 1 and Customer 2 are
The LCD now displays Sav EditArea to.
6.Press the key until the appropriate configuration area appears on the LCD, then press the corresponding function key to select your choice. (Saving configuration options to the Active (Saved) configuration area automatically saves them to the Active (Operating) configuration area.) The LCD displays Command Complete.
7.The modem is now configured with the selected factory template. Press the key to return to the
Refer to Chapter 4, DCP Configuration, for more information regarding default factory configuration options.
November 1996 |