AT Command Set and
Table
(6 of 12)
392xPlus S-Registers
Description | DCP LCD | |
Command | ||
|
| Sequence |
|
|
|
S52 | DTE LL (CT141). Register determines if the modem performs a local analog | Configure\Edit\ |
| loopback if it receives a CT141 signal from the DTE. | Tests |
| Register has the following values: |
|
| 0 = Disable |
|
| 1 = Enable |
|
| The factory setting is Disable. |
|
|
|
|
S53 | V.54 Address. Identifies the address of the modem to be placed in a loopback | Configure\Edit\ |
| test. | Tests |
| Register has the following values: |
|
| 0 = Disable |
|
| 1±34 = Modem address |
|
| The factory setting is Disable. |
|
|
|
|
S54 | V.54 Device Type. Identifies where the modem is physically located in the | Configure\Edit\ |
| network. | Tests |
| Register has the following values: |
|
| 0 = Peripheral |
|
| 1 = Intermediate |
|
| The factory setting is Peripheral. |
|
|
|
|
S55 | Access From Remote. Register determines if a modem's DCP can be | Configure\Edit\ |
| accessed by a remote modem. | Misc |
| Register has the following values: |
|
| 0 = Enable |
|
| 1 = Disable |
|
| The factory setting is Enable. |
|
|
|
|
S56 | Remote Access Password. Register allows entry of the first pair (leftmost) of | Configure\Edit\ |
| digits of a remote access password. Any value from 00 to 99 is valid. For | Misc |
| example, if the remote access password is 12345678, then S56 = 1 and 2. |
|
|
|
|
S57 | Remote Access Password. Register allows entry of the second pair of digits of | Configure\Edit\ |
| a remote access password. Any value from 00 to 99 is valid. | Misc |
|
|
|
S58 | Remote Access Password. Register allows entry of the third pair of digits of a | Configure\Edit\ |
| remote access password. Any value from 00 to 99 is valid. | Misc |
|
|
|
S59 | Remote Access Password. Register allows entry of the fourth pair (rightmost) | Configure\Edit\ |
| of digits of a remote access password. Any value from 00 to 99 is valid. | Misc |
|
|
|
November 1996 |
