Paradyne 392xPLUS operation manual S46

COMSPHERE 392xPlus Modems

Table 5-3

(5 of 12)

392xPlus S-Registers

S-Register		Description	DCP LCD
			Command
			Sequence
S46	Auto Dial Backup. Register determines if the modem performs an automatic		Configure\Edit\
	dial backup if the leased lines fail.		Leased Line
	Register has the following values:
	0	= Disable
	1	= Enable
	The factory setting is Disable.
S47	Auto Dial Standby. Register determines if the modem performs an automatic		Configure\Edit\
	dial standby if in Dial Backup mode.		Leased Line
	Register has the following values:
	0	= Disable
	1	= 15 minutes
	2	= 1 hour
	3	= 4 hours
	4	= Test(2min)
	5	= Adv 15min
	6	= Adv 30min
	7	= Adv 1 hr
	8	= Adv2minTest
	The factory setting is Disable.
S48	Leased-Line Carrier On Level. Register determines if the modem disconnects		Configure\Edit\
	if the carrier signal on leased lines falls below ±26 dBm or ±43 dBm.		Leased Line
	Register has the following values:
	0	= ±43 dBm
	1	= ±26 dBm
	2	= ±33 dBm
	The factory setting is country dependent (usually ±43 dBm). In France, the
	factory setting is ±26 dBm in 4-wire operation and ±33 dBm in 2-wire
	operation.
S49	Buffer Disconnect Delay. Register determines how long the modem continues		Configure\Edit\
	to transmit data stored in its buffers when the modem is commanded to		V42/MNP/Buffer
	disconnect by a locally attached DTE.
	Enter a value from 0±255 seconds. (A value of 0 disables this register.) The
	factory setting is 10 seconds.
S51	DTE RL (CT140). Register determines if the modem performs a remote digital		Configure\Edit\
	loopback if it receives a CT140 signal from the DTE.		Tests
	Register has the following values:
	0	= Disable
	1	= Enable
	The factory setting is Disable.

5-20 November 1996 3920-A2-GN31-30