Design Dynamics DVF-36S-N Fireplace Installation, Parts list for venting kits and components

Venting Installation

Continued

parts list for venting kits and components

DESA (5"/8") Pipe & Vent Kits

Number	Description
P58-6	6" Section Double Wall Pipe,
	Galvanized
P58-12	12" Section Double Wall Pipe,
	Galvanized
P58-24	24" Section Double Wall Pipe,
	Galvanized
P58-36	36" Section Double Wall Pipe,
	Galvanized
P58-48	48" Section Double Wall Pipe,
	Galvanized
PA58-712	Adjustable 7"-12" Section Double
	Wall Pipe, Galvanized
E58-45	45° Elbow, Galvanized
E58-90	90° Elbow, Galvanized
HTS-58	Horizontal Square Termination,
	Galvanized
VT-58	Vertical Round Termination,
	Galvanized
SC-58	Storm Collar, Galvanized
WF-58	Wall Firestop, Galvanized
RF-58-6	Roof Flashing - 0 to 6/12 Pitch,
	Galvanized
RF-58-12	Roof Flashing - 6/12 to 12/12 Pitch,
	Galvanized
VR-58	Vertical Restrictor, Galvanized
S-58	Vinyl Siding Standoff,
	Galvanized
WS-58	Wall Strap
CS-58	Cathedral Ceiling Support
FP-58	Firestop Plate
SF-58	Stucco Flashing -
	For use with HTS-58
RF-58	Flat Roof Flashing
AK6-37	37" Outside Air Flex Vent Kit
AK6-75	75" Outside Air Flex Vent Kit

Fireplace

Installation

CHECK GAS TYPE

Use proper gas type for the fireplace unit you are installing. If you have conflicting gas types, do not install fireplace. See retailer where you purchased the fireplace for proper fireplace according to your gas type.

Installing Gas Piping to Fireplace Location

WARNING: A qualified service person must connect fireplace to gas supply. Follow all local codes.

CAUTION: For propane/LP units, never connect fireplace directly to the propane/LP sup- ply. This heater requires an ex- ternal regulator (not supplied). Install the external regulator between the fireplace and pro- pane/LP supply.

WARNING: For natural gas, never connect fireplace to private (non-utility) gas wells. This gas is commonly known as wellhead gas.

Installation Items Needed

Before installing fireplace, make sure you

have the items listed below.

•external regulator (supplied by installer)

•piping (check local codes)

•sealant (resistant to propane/LP gas)

•equipment shutoff valve *

•test gauge connection *

•sediment trap

•tee joint

•pipe wrench

•approved flexible gas line with gas connec- tor (if allowed by local codes)

*A CSA design-certified equipment shutoff valve with 1/8" NPT tap is an acceptable al- ternative to test gauge connection. Purchase the CSA design-certified equipment shutoff valve from your retailer.

14 www.desatech.com 120441-01A