Design Dynamics DVF-36S-N Wiring Diagram, Operation, For your safety Read before lighting

Wiring Diagram

IGNITOR LEAD

ORANGE

EV1

EV2

PILOT

			BLUE
E12		SYNETEK CONTROLS	TRANSFORMER
	IS1070B		WHITE
E8			24V AC	120V AC
E6
E4
E3
E2
		INC	BLACK
			GROUND
			RED
GREEN

ADAPTER/ REMOTE RECEIVER

J-BOX

120 VAC

Operation

for your safety

Read before lighting

WARNING: If you do not fol- low these instructions exactly, a fire or explosion may result causing property damage, per- sonal injury or loss of life.

A.This appliance is equipped with an igni- tion device which automatically lights the pilot. Do not light pilot by hand.

B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

•Do not try to light any appliance.

•Do not touch any electric switch; do not use any phone in your building.

•Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.

C.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.

lighting

instructions

NOTICE: During initial operation of new fireplace, burning logs will give off a paper-burning smell. Orange flame will also be present. Open damper or window to vent smell. This will only last a few hours.

1.STOP! Read the safety information above.

2.Turn off all electric power to the fireplace.

3.Turn wall switch to the OFF position.

4.Remove center brick/control cover.

5.Turn equipment shutoff valve clock-

wise to the OFF position (see Figure 34, page 22). Do not force.

120441-01A www.desatech.com 21