DCP Operation
Table
(3 of 3)
Top-Level Menu Status
Status
Message
Indicates
Call Disconnect | ATH Disconnect | The modem has disconnected due to an ATH command. |
|
|
|
| Bad Lines Disc | The modem has disconnected because the lines do not support the |
|
| modulation and/or data rate selected. |
|
|
|
| No Carrier Disc | The modem disconnects due to the loss of carrier signal from the remote |
|
| modem. |
|
|
|
| DTR Disconnect | The modem has disconnected due to the loss of DTR from the DTE. |
|
|
|
| EC Disconnect | The modem has disconnected due to failure to negotiate Error Control |
|
| mode. |
|
|
|
| Inv Rate Disc | When using V.32bis modulation, the remote modem does not support the |
|
| data rate used by the local modem. |
|
|
|
| LnCurrnt Disc | The modem has disconnected due to the loss of line current. |
|
|
|
| LongSpace Disc | The modem has disconnected due to the detection of a long space. |
|
|
|
| NoData Disc | The modem has disconnected due to a lack of transmitted and received |
|
| data. |
|
|
|
| Disconnecting | The modem has begun the disconnect sequence. |
|
|
|
| RmtCmnded Disc | The modem has disconnected due to a V.32 Cleardown received from the |
|
| remote modem. |
|
|
|
| Talk Mode | The modem is in Talk mode. |
|
|
|
Firmware | DownldOnly | A local download of firmware or a remote cloning of firmware has failed. |
Download Result | Mode | The modem is currently in a Download Only mode in which only another |
|
| download attempt is possible. |
|
|
|
| Frmware | A local download of firmware or a remote cloning of firmware was |
| Upgrade | successful. |
|
|
|
| RemClone Failed | A remote cloning of firmware has failed. This message appears on the local |
|
| modem's LCD. |
|
|
|
| Remote Clone | A remote cloning of firmware was successful. This message appears on the |
| OK | local modem's LCD. |
|
|
|
| Bcast Clone | A broadcast cloning of firmware is complete. Look under the Control branch |
| Done | for multipoint cloning results. This message appears on the local modem's |
|
| LCD. |
|
|
|
AT Command Reset
Reset by AT command
The modem has performed a reset in response to an ATZ command.
November 1996 |
