
COMSPHERE 392xPlus Modems
The following sections describe the uses of the Talk/Data function.
Manual Dialing When the Remote Modem is Configured for
NOTE
On the remote modem, the Line Current Disconnect configuration option (refer to the Line Dialer section in Chapter 4) must be set to Disable.
This configuration option does not appear on Models
If you are originating a call using a telephone and the remote modem is configured for
Idle:28.8
Tlk/Data
F1 F2 F3
Press the
key until Tlk/Data appears.
Lift the attached handset and dial the telephone number of the remote modem. When the remote modem answers, it transmits an answer tone.
Idle:28.8
Tlk/Data
F1 F2 F3
When you hear this tone, immediately select Tlk/Data and hang up the handset. This starts the handshaking sequence between your modem and the remote modem.
Online:28.8 >
Call_Setup
F1 F2 F3
If this is successful, the modems are in Data mode and OnLine appears on the LCD.
November 1996 |