Paradyne 392xPLUS operation manual N5, X0

COMSPHERE 392xPlus Modems

Table 5-2

(9 of 9)

392xPlus AT Commands

AT			Description		DCP LCD
					Command
Command
					Sequence
\Nn	Error Control Mode.				Configure\Edit\
	\N0	Buffer Mode.			V42/MNP/Buffer
	\N1	Direct Mode.
	\N2	MNP or Disconnect.
	\N3	MNP or Buffer.
	\N4	V.42/MNP or Disconnect.
	\N5	V.42/MNP or Buffer.
	\N6	LAPM or Disconnect.
	\N7	LAPM or Buffer.
\Qn	Flow Control of DTE, Flow Control of Modem.				Configure\Edit\
			Flow Control	Flow Control	V42/MNP/Buffer
			of DTE:	of Modem:
		\Q0	Disable	Disable
		\Q1	XON/XOFF	XON/XOFF
		\Q2	CTS to DTE	Disable
		\Q3	CTS to DTE	RTS to Mdm
		\Q4	XON/XOFF	Disable
		\Q5	Disable	XON/XOFF
		\Q6	Disable	RTS to Mdm
\Tn	No Data Disconnect Timer.				Configure\Edit\
	\T0	Disable.			Line Dialer
	\Tn	Where n is a value from 1 to 255 in 1-minute increments.
	NOTE: The factory default value is country dependent.
\Xn	XON/XOFF Passthrough Flow Control.				Configure\Edit\
	\X0	Disable.			V42/MNP/Buffer
	\X1	Enable.
%An	Error Control Fallback Character.				Configure\Edit\
	%An	Where n is an ASCII value from 0 to 127. Factory default is 013			V42/MNP/Buffer
		ASCII.
%Cn	MNP5 Data Compression.				Configure\Edit\
	%C0	Disable.			V42/MNP/Buffer
	%C1	Enable.
IHn	V.42bis Compression.				Configure\Edit\
	IH0	Disable.			V42/MNP/Buffer
	IH1	Enable (Transmit (TX) only).
	IH2	Enable (Receive (RX) only).
	IH3	Enable (Transmit (TX) and Receive (RX)).

5-14 November 1996 3920-A2-GN31-30