Paradyne 392xPLUS operation manual Backup Status Screens, Line=Pri 4w APL, Line=Pri 2w APL

DCP Operation

Table 3-7 provides information about the Status Backup screens. The first column lists all possible configurations for the modem's currently active line. The second column lists all possible configurations for the modem's inactive lines. The third column provides information about the inactive line condition.

XXXX represents the condition code of the inactive line.

			Table 3-7
		Backup Status Screens
Active Line	Inactive Line			Possible Inactive/Backup Line Condition
1st Screen Display	2nd Screen Display
Line=Pri 4w APL	Bckup:2wAPL=XXXX			Good indicates that line continuity is detected.
or	or			Bad indicates that line continuity is not detected.
Line=Pri 2w APL	Bckup : Dial	=(blank)
				???? indicates that the line condition is unknown (Backup
				Facility Check is making its first determination of the line
				conditions since the last retrain).
				blank indicates that the BackupLineCheck configuration
				option is disabled or not available. Refer to the BackupLine
				Check configuration option in the Leased Line section of
				Chapter 4.
Line=Bkup 2w APL	Pri 4w APL	=XXXX		Good indicates the line condition is good.
or	or			Bad indicates the line condition is bad.
Line = Dial Backup	Pri 2w APL =XXXX
				???? indicates the line condition is unknown (Lease
				Lookback has not had enough time to make an initial
				appraisal of the line conditions since the last retrain).
				blank indicates the Lease Lookback option is disabled.
				Refer to the BackupLine Check configuration option in the
				Leased Line section of Chapter 4.
Line=Dial Only	No second screen			NOTE: When the modem is configured for Dial Only, there
	display.			is no backup.
				NOTE: The leased-line interface is disabled when the
				factory default options are loaded from the Async
				Dial, Sync Dial, or UNIX Dial templates.
Line=No Sync	No second screen			NOTE: No Sync appears when the modem is not trained on
	display.			either the primary or backup line facility.

To exit this function and remain in the Status branch, press the key. To exit and return to the

Top-Level menu, press the key.

3920-A2-GN31-30 November 1996 3-27