ASSEMBLY

GAUGE WHEEL

MOUN_NG

BRACKET"_.

LOCKNUT

3/8" WASHER

SHOULDER BOLT

GAUGE WHEEL

FIG. 4

INSTALL MULCHER PLATE

(See Figs. 5 & 6)

Install two latch hooks to mulcher plate using screw, washer, lock washer, and weld nut as shown.

NOTE: Pre-assemble weld nut to latch hook by inserting weld nut from the top with hook pointing down.

Tighten hardware securely.

Raise and hold deflector shield in upright position.

Place front of mulcher plate over front of mower deck opening and slide into place, as shown.

Hook front latch into hole on front of mower deck.

Hook rear latch into hole on back of mower deck.

CAUTION: Do not remove discharge guard from mower. Raise and hold guard when attaching mulcher plate

and allow it to rest on plate while in operation.

WELD NUT FROM THE TOP HOOK POINTS DOWN

LOCK

WELD WASHER

I

TO CONVERT TO BAGGING OR

DISCHARGING

Simply remove mulcher plate and store in a safe place,

Your moweris nowreadyfor dischargingor installationof optionalgrasscatcheraccessory.

DEFLECTOR

LATCH

HOOKS

FIG. 6

,/CHECKLIST

BEFORE YOU OPERATE AND ENJOY YOUR NEW TRACTOR, WE WISH TO ASSURE THAT YOU RECEIVE THE BEST PERFORMANCE AND SATISFACTION FROM THIS QUALITY PRODUCT.

PLEASE REVIEW THE FOLLOWING CHECKLIST:

,/ All assembly instructions have been completed.

,/ No remaining loose parts in carton.

,/ Battery is properly prepared and charged. (Minimum 1 hour at 6 amps).

/Seat is adjusted comfortably and tightened securely.

,/ All tires are properly inflated. (Forshipping purposes, the tires were overinflated at the factory).

/ Be sure mower deck is properly leveled side-to-side/ front-to-rear for best cutting results. (Tires must be properly inflated for leveling).

,/ Check mower and drive belts. Be sure they are routed properly around pulleys and inside all belt keepers.

NUT_

LATCH

LOCK

HOOK

WELD NUT

,/ Check wiring. See that all connections are still secure and wires are properly clamped.

WHILE LEARNING HOW TO USE YOUR TRACTOR, PAY EXTRA A TTENTION TO THE FOLL OWING IMPORTANT ITEMS:

,/ Engine oil is at proper level.

/

Fuel tank is filled with fresh, clean, regular unleaded

 

gasoline.

WASHER

WASHER

,/ Become familiar with all controls - their location and function. Operate them before you start the engine.

MULCHER PLATE

/Be sure brake system is in safe operating condition.

FIG. 5

9

Page 9
Image 9
Craftsman 917.259561 owner manual Checklist, To Convert to Bagging or, Discharging, Install Mulcher Plate