NOTE::l'h_odginal equipment battery on
your tractor is maintenance free. Do not attg_mptto open Or remove caps or covers. Addihg or checking level of electrolyte is
not necessary.
TO CLEAN BATTERY AND TERMINALS
Corrosion and dirt on the battery and ter- minals can cause the battery to "leak"
power.
•Open battery box door.
•DisconnectBLACK battery cable first then RED battery cable and remove battery from tractor.
•Rinse the battery with plain water and
Clean terminals and battery cable ends withwire brush untilbright.
•Coat terminals with grease or petroleum jelly.
•Remstall,,ba=ttery(See =REPLACING
manual).
Check
after 100 hours of operation and replace if necessary. The belts are not adjustable.
Replace._be!tsifthey begin to slip from wear.
TRANSAXLE COOLING
Keep transaxle free from
ENGINE LUBRICATION
Only use high quality detergent oil rated with API service classification SF, SG or
•according to your expected operating tem- perature.
SAE VLSCOSITYGRADES
roll
| . | ,o. | ,. |
"rEM_I_llJRE | RANGE _T_ATED | 8EFI_E. NEXT OK.¢.,lt_C_ |
NOTE: Although multi:Viscosityoils (5W30, 10W30 etc.) improve starting in cold weather, these
Change the oil after every 25 hours of operation or at least once a year if the tractor is not•used for 25 hOursin one
year,
Check thecrankcase oil level before start-
:stlL"IL_ect_'elyeach time you check the oil level.
TO CHANGE ENGINE OIL
Determine temperature range expected before oil change. All oil must meet API service classificationSF, SG or SH.
•Be sure tractor is on level surface.
•Oil will drain more freely when warm.
•Catch oi!in a sui_ble container.
•• Remove oil fill cap/dipstick, Be careful
not to allow dirtto enter the engine when changing oil.
•Remove drain plug.
••After oil has drained completely, replace oil drain plug and tighten securely.
•Refill engine with oil through oil fill dip- stick tube. Pour slowly.Do not overfill. For approximate capacity see "PROD- UCT SPECIFICATIONS =Ton page _ of this manual.
•Use gauge on oil fill cap/dipstick for checking level. Be sure dipstick cap is tightened securely for accurate reading. Keep oil at =FULL" line on dipstick.
Oil Drain
AIR FILTER ..
Your engine will not runproperly using a dirty ajrfllter. Clean the foam
Service air cleaner more often under dusty" conditions.
•Remove knob(s) and cover.
TO SERVICE
•Slide foam pre..cleaner off cartridge.
•Wash it in liquid detergent and water.
•Squeeze it dry in a clean cloth.
•Saturate it in engine oil. Wrap it in clean,
absorbent cloth and squeeze to remove excess oil.
•If very dirty or damaged, replace pre- cleaner.
•Reinstall
•Reinstallcover and secure with knob(s).
TO SERVICE CARTRIDGE
• Remove cartridge nut. .
•Carefully remove cartridge to prevent debris from entering carburetor.Clean
base Carefully to prevent debris from entering carburetor.
•Clean cartridge by tapping gently on flat surface. If very dirty or damaged, replace cartridge.
20