![the-Assemblysectionof this manual.](/images/new-backgrounds/84879/8487949x1.webp)
rRANSAXLE SHIFTER UNKAGEAND
_DJUSTMENT
The transaxle should _ in neutral when the ge
:lock gate) position. The adjustment is )reset at the factory;,however, if adjust- 1lent is needed, proceed as follows:
•Make sure tmnsaxle is inneutral (N).
•Loosen two Iocknuts on tie rod.
•Tighten Iocknuts securely.
Neutral Lock
Gate
Locknuts
Tie
Transaxle
TO ADJUST STEERING WHEEL AUGN- MENT
If steering wheel crossbars are not hori- zontal (left to right) when wheelsare posi- tioned straight forward, remove steering wheel and reassemble per instructions in
the-Assemblysectionof this manual.
JERONT WHEEL
The front wheel
adjustable on your
TO REMOVE WHEEl: FOR REPAIRS
•Block up axle securely.
•Remove axle cover, retaining ring and washers to allow wheel removal (rear wheel contains a square key - Do not
lose)."
•Repair tire and reassemble.-
•On.. _..ee_ only:.,align grooves_ in rear Wheel hub and axle. Insert square
key,':. _
•Replace washers and snap retain'rag
ringsecurelyin axle groove.
•Replaceaxlecover.
NOTE: To seal tire punctures and prevent flat tires due to slow leaks; tire sealant may be purchased from your local pads
dealer. Tire sealant also prevents tire dry rot and corrosion.
Washers
• Ret=n_ng
R_
| ! |
|
Axle Cover | "_Square | Key |
(Rear Wheel Only)
TO START ENGINE THAT HAS A WEAK
BATTERY
&CAUTION:
If your battery is too weak to start the
engine, it should be recharged. (See
If=jumper cables', are used for emergency starting, follow this procedure:
JLIMPORTANT: Your tractor Is equiped
with a 12 volt negative grounded system. The other vehical must also be a 12 volt
negative grounded system. Do not use your tractor battery to start other vehicais.
TO ATI'ACHJUMPER CABLES -
•Connect each end of the RED cableto the POSITIVE (+)terminal of each bat-
tery, taking care not to short against chassis.
•Connect one end of the BLACK cable to
the NEGATIVE
•Connect the other end of the BLACK
cable to good CHASSIS GROUND, away from fuel tank and battery.
TO REMOVE CABLES, REVERSE
ORDER- =: :
•BLACK cable first from chassis and then from the fully charged battery.
•RED cablelast from both batteries.
25