PositiveTerm/.hal
Charged
Battery
Positive Terminal
Negative Terminal
Hex Bolt
Positive (Red) Cable Negative (Black) Cable
TO REP=LACE HEADLIGHT BULB
•Raise hood.
•Pull bulb holder out of the hole in the backside of the grill.
•Replace bulb in holder and push bulb holder securely back intothe hole in the backside of the grill.
•Close hood.
REPLACING •BATTERY
ACAUTION: Do not short battery termi- nals by allowing a wrench or any other object to contact both terminals at the same time. •Before connecting battery, remove metal bracelets, wristwatch
bands,rings,etc.
Positive terminal must be connected first to
grounding.'
•Lift seat pan to raised position and open battery box door.
•Disconnect BLACK batterycable first
then RED battery cable and carefully remove battery from tractor.
•First connect RED battery cable to posi- tive (+) terminal with hex bolt and nut as shown. Tighten securely.
ConnectBLACK grounding cable to negative
Close battery box door.
Seat Pan
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run poorly, stoprunning, or pre- vent it from starting.
•Check wiring. See electrical wiring dia-
gram in the Repair Parts section of this manual.
TO REPLACE FUSE
Replace with 30 amp
TO REMOVE HOOD AND GRILL
ASSEMBLY
•Raise hood.
•Unsnap headlight wire connector.
•Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.
•To replace, reverse above procedures.
Battery Box Door
ENGINE
Maintenance, repair, or replacement of the emission control devices and systems, which are being done at the customers expense, may be performed by any •non- road engine repair establishment or indi- vidual. Warranty repairs must be per- formed by an authorized engine manufac-
26 turer'sservice outlet.
