all partsandhardwareyou assemblemust be tightened securely. Use the correct tools as necessary to insure proper tightness. Review the video cassette before you begin.
TOOLS | REQUIRED | FOR | • Position steering wheel so cross bars | |||
ASSEMBLY |
| are horizontal (left to right) and slide | ||||
|
|
|
| inside boot and onto adapter. | ||
A socket wrench set will make assembly |
| |||||
|
|
|
| • Assemble large flat washer, 3/8 lock | ||
easier. Standard wrench sizes you need |
| |||||
are | listed | below. |
| washer, 3/8 hex bolt and tighten securely. | ||
| • Snap steering wheel insert into center | |||||
(1_)9/16" | wrench |
| ||||
(1) Phillips Screw | wheel. | |||||
(2) | 1/2" wrench | ddver | of steering | |||
• Remove protective materials from trac- | ||||||
(1) | Pliers |
| (1)Tirepressure | |||
| tor hood and grill. | |||||
(1) | Utility | knife | gauge | |||
IMPORTANT: | Check for and remove any | |||||
(1) | 3/4" wrench socket |
| ||||
| staples in skid that may puncture tires | |||||
drive.mchet |
| |||||
| where tractor is to roll off skid. | |||||
|
|
|
| |||
When right or left hand is mentioned in |
| |||||
this | manual, it means, | from your point | of | Insert | ||
view, when you are in the operating posi- |
| |||||
tion (seated behind the steering wheel). |
| |||||
TO REMOVE TRACTOR FROM
CARTON
•Remove all accessible loose parts and parts boxes from shipping carton (See page 6),
•Cut, from top to bottom, along lines on all four comers of shipping carton, and lay panels flat.
•Check for any additional loose parts or boxes and remove.
Lockwasher
3/8 He_ Bolt
Large Flat
Stee__iillr
Wheel
BEFORE ROLLING TRACTOR OFF SKID
ATTACH STEERING WHEEL
ASSEMBLE EXTENSION SHAFT AND
_ BOQT_
•Slide extension shaft onto lower steer-
ing shaft. Align mounting holes in exten- sion and lower shafts and install 5/16
hex bolt and Iocknut. Tighten securely. IMPORTANT: Tighten bolt and nut secure- ly to
•• Place tabs of steering boot over tab slots in dash and push down to secure.
INSTALL STEERING WHEEL
•Position front wheels of the tractor so they are pointing straight forward.
•Slide steering'wheel adapter onto steer-
TOROLL TRACTOR OFF SKID (See Operation section for location and function of controls)
•Press lift lever plunger and raise attach- ment lift lever to its highest position.
•Release parking brake by depressing clutch/brake pedal.
•Place gearshift lever in neutral (N) posi- tion.
•Roll tractor forward off skid.
•Remove banding holding discharge guard up against tractor.
8
