ClampClamp
Fuel Filter
CLEANING
•Clean engine, battery, seat, finish, etc. of all foreign matter.
•Keep finished surfaces and wheels free of all gasoline, oil, etc.
•Protect painted surfaces with automo-
tive type wax.
We do not recommend using a garden hose to clean your tractor unless the elec- trical system, muffler, air filter and carbure- tor are covered to keep water out. Water
in engine can result in a shortened engine life.
_,CAUTION: Before performing any service or adjustments:
•Depress clutch/brake pedal fully and set parking brake.
•Place motion control lever in neutral (N) position.
•Place attachment clutch in =DISENGAGED" position.
•Tum ignition key "OFF" and remove key.
•Make sure the blades and all moving parts have completely stopped.
•Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.
TO REMOVE MOWER
Mower will be easier to remove from the right side of tractor.
•Place attachment clutch in "DISEN- GAGED" position.
•Move attachment lift lever forward to lower mower to its lowest position.
•Roll belt off engine pulley.
•Disconnect clutch red from clutch lever by removing retainer spring.
•Disconnect
•Disconnect suspension arms from rear
deck brackets by removing retainer springs.
Suspe_on
Arms
Retainer
Spring
•Disconnect front links from deck by removing retainer springs.
•Raise lift lever to raise suspension arms. Slide mower out from under trac- tor.
IMPORTANT: If an attachment other than the mower deck is to be mounted on the tractor, remove the front links.
TO INSTALL MOWER
•Raise attachment lift leverto its highest position.
•Slide mower under tractor with dis- charge guard to right side of tractor.
•Lower lift lever to its lowest position.
•Install mower in reverse order of removal instructions.
Retainer
Engine Pulley
•Front Link
;pdngs
(BothSides)
;pdngs
(Both Sides)
23