TO ATTACH JUMPER CABLES -
•Connect each end of the RED cable to the POSITIVE (+) terminal of each bat-
tery, taking care not to short against chassis.
•Connect one end of the BLACK cable to the NEGATIVE
•Connect the other end of the BLACK cable to good CHASSIS GROUND, away from fuel tank and battery.
TO REMOVE CABLES, REVERSE ORDER -
•BLACK cable first from chassis and then from the fully charged battery.
•RED cable last from both batteries.
=Positive" (+) | "Negative" |
L.H.Panel | / |
Bolt |
|
REPLACING BATTERY
&,CAUTION: Do not short battery termi- nals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatch
bands,rings,etc.
Positive terminal must be connected first to prevent sparking from accidental grounding.
•Lift hood to raised position.
•Remove terminal guard.
•Disconnect BLACK battery cable then RED battery Cable and carefully remove battery from tractor.
•Install new battery with terminals in same position as old battery.
•Reinstall terminal guard.
•First connect RED battery cable to posi- tive (+) battery terminal with hex bolt
and keps nut as shown. Tighten secure-
ly.
•Connect BLACK grounding cable to negative
remaining hex bolt and keps nut.
Tighten securely.
•Close terminal access doom.
•Close hood.
Hex Bolt
Terminal Kep_ut
Door
Termin_
Is
(Black) Cable
TO REPLACE HEADLIGHT BULB
•Raise hood.
•Pull bulb holder out of the hole in the backside of the grill.
•Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.
•Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run poorly, stop running, or pre- vent it from starting.
•Check wiring. See electrical wiring dia- gram in the Repair Parts section of this manual.
TO REPLACE FUSE
Replace with 30 amp
27
