BELTINSTALLATION-
•Installnewbolt in reverseorder of removal.
Mandrel
Pulley
Mandrel
Pulley
•Make sure bolt is in all pulley grooves and inside all belt guides.
•Install mower in reverse order of removal instructions.
Idler
Pulleys
TO ADJUST BRAKE | ' TO REPLACE MOTION DRIVE BELT |
Your tractor is equipped with an adjustable brake system which is mounted on the side of the transaxle,
If tractor requires more than six (6) feet stopping distance at high speed in highest gear, then brake must be adjusted.
•Depress clutch/brake pedal and engage parking brake,
•Measure distance between brake oper- ating arm and nut =A"on brake rod.
•If distance is other than
•Road test tractor for proper stopping
., distance as stated above. Readjust if necessary. If stopping distance is still greater than six (6) feet in highest gear, further maintenance is necessary.
Contact your nearest authorized sero vice center/department.
With ParkingBrake
Jam =Engaged"
Park the tractor on level surface. Engage parking brake. For assistance, there is a belt installation guide decal on bottom sid_
of left footrest.
•Remove mower (See "TO REMOVE
MOWER" in this section of this manual.)
•Remove belt from stationary idler and clutching idler.
•Pull belt slack toward rear of tractor. Carefully remove belt upwards from transmission input pulley and over cool- ing fan blades.
•Pull belt toward front of tractor and remove downward from around engine pulley.
•Install new belt by reversing above pro- cedure.
Engine
Pulley_
Clutching
StationaryIdler_ "0
Transmission
"A" | Input Pulley _ | _.I_ |
Do Not touch this nut. If further brake adjust- |
|
ment is necessary contact your nearest autho- |
|
rized service center/department | 25 |