Motion Control Lever

Neutral

 

Lock Gate

':Adjustment Bolt

TRANSMISSION REMOVAL/REPLACE- MENT

Should your transmission require removal for service or replacement, it should be purged after reinstallation and before operating the tractor. See =PURGE

TRANSMISSION" in the Operation section of this manual.

TO ADJUST STEERING WHEEL ALIGN- MENT

If steering wheel crossbars are not hori- zontal (left to dght) when wheels are posi- tioned straight forward, remove steering wheel and reassemble per instructions in the Assembly section of this manual.

FRONT WHEEL TOE-IN/CAMBER

The front wheel toe-in and camber are not

adjustable on your tractor. If damage has occurred to affect the front wheel toe-in or

camber, co_ntactyour nearest authorized service center/department.

TO REMOVE WHEEL FOR REPAIRS

Block up axle securely.

Remove axle cover, retaining ring and washers to allow wheel removal (rear wheel contains a square key - Do not lose).

Repair tire and reassemble.

On rear wheels only:,align grooves in rear wheel hub and axle. Insert square key.

Replace washers and snap retaining ring securely in axle groove.

Replace axle cover.

NOTE: To seal tire punctures and prevent fiat tires due to slow leaks, tire sealant

may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

TO START ENGINE WITH A WEAK BATTERY

=,CAUTION: Lead-acid batterias gener- ate explosive gases. Keep sparks, flame and smoking materials away from batter- ies. Always wear eye protection when around batteries.

If your battery is too weak to start the

engine, it should be recharged. (Sea

"BA'I-I'ERY"in the MAINTENANCE sec- tion of this manual).

If "jumper cables" are used for emergency starting, follow this procedure:

IMPORTANT: Your tractor Is equipped

with a 12 volt negative grounded system. The other vehicle must also be a 12 volt

negative grounded system. Do not use your tractor battery to start other vehicles.

TO ATTACH JUMPER CABLES -

Connect each end of the RED cable to the POSITIVE (+) terminal of each bat-

tery, taking care not to short against chassis.

Connect one end of the BLACK cable to the NEGATIVE (-) terminal of fully charged battery.

Connect the other end of the BLACK cable to good CHASSIS GROUND, away from fuel tank and battery.

TO REMOVE CABLES, REVERSE ORDER -

BLACK cable first from chassis and then from the fully charged battery.

RED cable last from both batteries.

Positive Terminal

Terminal

Washers

Battery

PositiveTerminal

Negative Terminal

R_r.tainin, _ fr_

 

- rsw

25

Page 25
Image 25
Craftsman 917.27108 To Adjust Steering Wheel ALIGN- Ment, Front Wheel TOE-IN/CAMBER, To Remove Wheel for Repairs