NOTE: The original equipment battery on
your tractor is maintenance free. Do not attempt to open or remove caps or covers. Adding or checking level of electrolyte is not necessary.
TO CLEAN
1.Open battery box door.
2.Disconnect BLACK battery cable first then RED battery cable and remove battery from tractor.
3.Rinse the battery with plain water and dry.
4.Clean terminals and battery cable ends with wire brush until bright.
5.Coat terminals with grease or petro- leum jelly.
6.Reinstall battery (See "REPLACING
TRANSAXLE COOLING
The transmission fan and cooling fins should be kept clean to assure proper cooling.
Do not attempt to clean fan or transmission while engine is running or while the transmission is hot. To prevent possible damage to seals, do not use high pressure water or steam to clean transaxle.
•Inspect cooling fan to be sure fan blades are intact and clean.
•Inspect cooling fins for dirt, grass clippings and other materials. To prevent damage to seals, do not use compressed air or high pressure sprayer
to clean cooling fins.
TRANSAXLE PUMP FLUID
The transaxle was sealed at the factory and fluid maintenance is not required for the life of the transaxle. Should the
transaxle ever leak or require servicing, contact a Sears or other qualified service center.
Check
Replace belts if they begin to slip from wear.
ENGINE
LUBRICATION
Only use high quality detergent oil rated with API service classification
03o 32 4o
_0 | "20 | 0 | 10 | 20 | 30 | 40 |
TEMPERATURE RANGE AN3"ICIPATED BEFORE NEXT OIL CHANGE
Change the oil after every 50 hours of operation or at least once a year if the tractor is not used for 50 hours in one
year.
Check the crankcase oil level before starting the engine and after each eight
(8) hours of operation.
TO CHANGE ENGINE OIL
Determine temperature range expected before oil change. All oil must meet API service classification
•Be sure tractor is on level surface.
•Oil will drain more freely when warm.
•Catch oil in a suitable container.
1.Remove oil fill cap/dipstick. Be careful not to allow dirt to enter the engine
when changing oil.
2.Remove yellow cap from end of drain valve and install the drain tube onto
the fitting.
Oil Drain Valve
C'°dSed__1
Drain Tube
3.Unlock drain valve by pushing inward slightly and turning counterclockwise,
4.To open, pull out on the drain valve.
5.After oil has drained completely, close and lock the drain valve by pushing inward and turning clockwise until the pin is in the locked position as shown.
6.Remove the drain tube and replace
the cap onto the end of the drain valve.
7.Refill engine with oil through oil fill dipstick tube. Pour slowly. Do not overfill. For approximate capacity see
"PRODUCT SPECIFICATIONS" section of this manual.
2O