The operation of any tractor can result in foreign objects thrown into the J
eyes, which can result in severe eye damage. Always wear safety J
glasses or eye shields while operating your tractor or performing any J
adjustments or repairs. We recommend standard safety glasses or a I
wide vision safety mask worn over spectacles. | J |
HOW TO USE YOUR TRACTOR
TO SET PARKING BRAKE
Your tractor is equipped with an operator presence sensing switch. When engine
is running, any attempt by the operator to leave the seat without first setting the parking brake will shut off the engine.
1.Depress clutch/brake pedal all the way down and hold.
2.Pull parking brake lever up and release pressure from clutch/brake pedal. Pedal should remain in brake
position. Make sure parking brake will hold tractor secure.
Attachment Clutch Lever =Engaged" Position
| _ |
|
| Ignition | Key |
__/ |
|
|
| _isengaged" | |
Throttle/_ | _7_//Position | .. |
| ||
Choke | "__t : | \ _\\__ |
| ||
Contr_ | _ | .\:, | _\\_ | Parking |
|
Clutch/ | __, | "Eneaaed | |||
Brake Peda |
|
| Pos_io_ |
| |
/ | _ | Motion | Control | ||
_ | _'Biiake""._ | Lever |
| ||
"Disengaged" | Position |
|
| ||
Position |
|
|
|
|
|
STOPPING
MOWER BLADES -
•To stop mower blades, move attach- ment clutch lever to "DISENGAGED"
position.
GROUND DRIVE -
•To stop ground drive, depress clutch/ brake pedal all the way down.
•Move motion control lever to neutral (N) position.
IMPORTANT: The motion control lever does not return to neutral (N) position when the clutch/brake pedal is de- pressed.
ENGINE -
•Move throttle control to slow position.
NOTE: Failure to move throttle control to
slow position and allowing engine to idle
before stopping may cause engine to "backfire".
•Turn ignition key to "STOP" position and remove key. Always remove key
when leaving tractor to prevent unauthorized use.
• Never use choke to stop engine. | 13 |
|
IMPORTANT: Leaving the ignition switch in any position other than "STOP" will
cause the battery to discharge and go dead.
NOTE: Under certain conditions when tractor is standing idle with the engine running, hot engine exhaust gases may cause "browning" of grass. To eliminate
this possibility, always stop engine when stopping tractor on grass areas.
A CAUTION: Always stop tractor completely, as described above, before leaving the operator's position.
TO USE THROTTLE CONTROL Always operate engine at full throttle.
•Operating engine at less than full
throttle reduces the battery charging rate.
•Full throttle offers the best bagging and mower performance.
TO MOVE FORWARD AND BACKWARD
The direction and speed of movement is controlled by the motion control lever.
1.Start tractor with motion control lever in neutral (N) position.
2.Release parking brake.
3.Slowly move motion control lever to desired position.
TO ADJUST MOWER cu'rrlNG HEIGHT The position of the attachment lift lever determines the cutting height.
•Grasp lift lever.
•Press plunger with thumb and move lever to desired position.
The cutting height range is approxi- mately
•The average lawn should be cut to
approximately
during hot months. For healthier and better looking lawns, mow often and after moderate growth.
•For best cutting performance, grass
over 6 inches in height should be mowed twice. Make the first cut
relatively high; the second to desired height.