TROUBLESHOOTING CHART:
See appropriate section in manual unless directed to Sears service center
PROBLEMCAUSE
Mower blades will 2. | Worn/damaged | mower | |
not rotate (con't) | drive belt. |
| |
3. | Frozen | idler pulley. | |
4. | Frozen | blade | mandrel. |
Poor grass1. Engine speed too slow. discharge
2.Travel speed too fast.
3.Wet grass.
4.Mower deck not level.
5.Low/uneven tire air pressure
6.Worn, bent or loose blade.
7.Buildup of grass, leaves and trash under mower.
8.Mower drive belt worn.
9.Blades improperly installed.
10.Improper blades used.
11 .Clogged mower deck vent
holes from buildup of grass, leaves, and trash around mandrels.
CORRECTION
2.Replace mower drive belt.
3.Replace idler pulley.
,4. Contact aSears or other qualified service center.
1.Place throttle control in "FAST" position.
2.Shift to slower speed.
3.Allow grass to dry before mowing.
4.Level mower deck.
5.Check tires for proper air pressure.
6.Replace/sharpen blade. Tighten blade bolt.
7.Clean underside of mower housing.
8.Replace mower drive belt.
9.Reinstall blades sharp edge down.
10.Replace with blades listed in this manual.
1.Clean around mandrels to open vent holes.
Headlight(s) not working
(if so equipped)
Battery will not charge
Loss of drive
1.Switch is "OFF".
2.Bulb(s) or lamp(s) burned out
3.Faulty light switch.
4.Loose or damaged wiring.
5.Blown fuse.
1.Bad battery cell(s).
2.Poor cable connections.
3.Faulty regulator (if so equipped).
4.Faulty alternator.
1.Freewheel control in
"disengaged" position.
2.Motion drive belt worn, damaged, or broken.
3.Air trapped in transmission during shipment or servicing.
1.Turn switch "ON".
2.Replace bulb(s) or lamp(s).
3.Check/replace light switch.
4.Check wiring and connec- tions.
5.Replace fuse.
1.Replace battery.
2.Check/clean all connec- tions.
3.Replace regulator.
4.Replace alternator.
1.Place freewheel control in
"engaged" position.
2.Replace motion drive belt.
3.Purge transmission.
Engine "backfires" when turning
engine "OFF"
. | Engine | throttle | control not | . Move throttle control | to | |
| set at "SLOW" |
| "SLOW" | position and | allow | |
| position | for 30 | seconds | |||
| to idle for 30 seconds | before | ||||
| before | stopping | engine. | stopping | engine. |
|
32