Your new tractor has been assembled at the factory with the exception of those parts
left unassembled for shipping purposes. To ensure safe and proper operation of your
tractor all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to insure proper tightness. Review the video cassette before
you begin.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly easier. Standard wrench sizes you need
are | listed below. |
|
|
(1) | 9/16"wrench | (1) | Pliers |
(2) | 1/2" wrench | (1) | Utility knife |
(1)Tire pressure gauge
When right or left hand is mentioned in this manual, it means, from your point of view, when you are in the operating position (seated behind the steering
wheel).
TO REMOVE TRACTOR FROM
CARTON
UNPACK CARTON
6.Assemble large flat washer, 3/8 lock washer, 3/8 hex bolt and tighten securely.
7.Snap steering wheel insert into center of steering wheel.
8.Remove protective materials from tractor hood and grill.
IMPORTANT: Check for and remove any
staples in skid that may puncture tires where tractor is to roll off skid.
Hex Bolt
Insert
3/8 Lock Washer
_LargeFlat
1. Remove all accessible loose parts | Washer | |
and parts boxes from carton. | ||
Boot | ||
2. Cut, from top to bottom, along lines | ||
Steering Wheel | ||
on all four corners of carton, and lay | ||
.Tabs | ||
panels flat. | ||
|
3.Check for any additional loose parts or cartons and remove.
BEFORE REMOVING TRACTOR FROM SKID
ATTACH STEERING WHEEL
ASSEMBLE EXTENSION SHAFT AND BOOT
1.Slide extension shaft onto lower
steering shaft. Align mounting holes in extension and lower shafts and install 5/16 hex bolt and Iocknut.
Tighten securely.
IMPORTANT: Tighten bolt and nut securely to
2.Place tabs of steering boot over tab
slots in dash and push down to secure.
INSTALL STEERING WHEEL
3.Position front wheels of the tractor so they are pointing straight forward.
4.Remove steering wheel adapter from steering wheel and slide adapter onto steering shaft extension.
5.Position steering wheel so cross bars are horizontal (left to right) and slide inside boot and onto adapter.
| .i_tension |
| Shaft | |
5/16 Locknut / |
| _5/t6 | Hex Bolt | |
Lower |
|
| L |
|
• | "':. | ' _" | I |
|
Steennn / | ."/_._ |
| ||
Shaft | _ | "'- _ |
| Tab |
|
| "'- | ' ' | Slots |
CHECK BATTERY
1.Lift seat pan to raised position.
NOTE: If this battery is put into service after month and year indicated on label (label located between terminals) charge battery for minimum of one hour at
8
