20
INSTALLATION
Installing Log Set (Cont.)
Decorative Facing
PILOT ASSEMBLY ADJUSTMENT
INSTALLATION
Continued
7.Figure 43 shows the top view of the burner and grate.
8.Place logs “A” as shown in Figure 44.
9.Place logs “B” as shown in Figure 45. Lift the end of log “A” that will be propped up and place log “B” under it. At the same time, the other side of log “B” is placed over the other log “A”. Repeat procedure for the other log “B”.
10.Take twigs “C” (shaped like a “Y”) and place them as shown in Figure 46.
11.Take twigs “D” (bent twig) and place them as shown in Figure 46.
12.Place twig “E” across the top of logs “B” a shown in Figure 46.
13.When finished installing the logs, close the glass doors while making certain that the safety door switch is fully depressed by the door frame before securing the four (4) spring loaded latches.
14.Replace the louvers in reverse order with the grilles pointing in the down position.
| Left |
Back | Front |
Right
Figure 43 - Burner and Grate (Top View)
Left
WARNING: Improper installation, adjustment, al- teration, service, or maintenance can cause injury or property damage. Refer to this manual. For assis- tance or additional information, consult a qualified installer, service agency, or gas supplier.
|
| Left |
|
| D |
| C |
|
|
| |
Back |
| E | Front |
|
|
|
C 
D 
Right
Figure 46 - Installing Twigs “C, D, E ” (Top View)
DECORATIVE FACING
Any noncombustible material may be used for facing (glass, tile, brick, etc.) as long as the proper clearances are observed (see Clearances, page 5). IMPORTANT: Louvered openings must not be obstructed, and upper and lower panels must remain removable for servicing. Use only
Note: Combustible material, such as wood, that has been fire- proofed is not considered noncombustible.
Back | Front |
Right
Figure 44 - Installing Logs “A” (Top View)
|
| Left |
| |
Back |
| A | Front | |
B | B | |||
|
| |||
|
|
| ||
|
| A |
|
Right
Figure 45 - Installing Logs “B ” (Top View)
PILOT ASSEMBLY
ADJUSTMENT
The pilot assembly is factory preset for the proper flame height. Alteration to these settings may have occurred during shipping and handling. If this is the case, some minor adjustment may be necessary and should be done by a qualified technician. To access the pilot assembly, the glass door must be opened. The proper settings for the thermopile height should be at a distance of 3/8" to 1/2" from the pilot flame as shown in Figure 47.
1/8" |
|
(0.3cm) | 3/8" - 1/2" |
| |
|
Figure 47 - Correct Pilot Flame Pattern
For
.
.com
