Matsushita CF-18NHHZXBM service manual Setting the Wireless Module, the Port PCB, and the Modem

7.2.12. Setting the Wireless Module, the Port PCB, and the Modem

1.Fix the Battery Connect Angle using the two Screws <K>.

2.Connect the Modem cable to the Connector, and fix the Modem on the Main PCB using the two Screws <J>.

3.Fix the Port PCB on the Main PCB using the three Screws <I>.

4.Connect the Wireless Module to the Main PCB, and con- nect the two Antenna Cables (J5, J6) to the Wireless Module.

Screws <I>:DRSB2+5FKL

Screws <J>:XSB2+4FNL

Screws <K>:DRSB2+5FKL

<J>
<K> <J>	<I>	<I>
<K>	Modem	<I>
		Port PCB
Bat Con Angle		Wireless Module

Connector (J5)

Connector (J6)

!Assembly of the Port PCB

Portre Sheet

Ensure it does not come						Port PCB
over the end of the Board
by 0.5 mm or more.							Ensure the Board does not
					0~0.5mm		run over the dowel.
DU Connetor Angle						0~0.5mm
		Tape Match the center of the Sheet
				to the end of the DU Connector.
				(-1 to +1 mm)
	Back side			Attach the surplus
				length to the edge of the Board.
Antenna PCB					DU Sponge B
			Match to the center			0~0.5mm
DU Sponge			of the Board.
			(-1 to +1 mm)
D
0~0.5mm
		Match to the center				0~0.5mm
		of the Board.			DU Sponge B
		(-1 to +1 mm)

7-25