Matsushita CF-18NHHZXBM Line Processing of Main Unit, Line Processing of the Lithium Battery, CN3

!Line Processing of Main Unit

Screw(D Sub)

Tape

Screw	Screw
Screw
	Connect.

Safety Working

I/O PCB ASSY

Safety Working

Insert the surplus

length between the Modem Connector and

the LAN Connector.

Screw

	HDD Guide Plate
			When inserting,
		Screw
			use the jig to receive
Between the Main Board
			the Cable.
and the Top Case

White

Modem

Connector

LAN

Connector

Connect it first when setting the Main Board. Then attach the Coin Battery to the Top Case.

Screw

0~2mm

0~0.5mm

Bat Cushion Screw

FFC CN

Stopper

Avoid running over the Modem Connector and the LAN Connector (yellow area).

MAIN PCB

Main PCB Switch

Connect the FFC.

After connecting the FFC, shape it over the Board.

Bat Con Angle 0~0.5mm

Screw

Then insert the shaped part to the BAT Connector.

Match to	Attach before
the edge	setting
of the	the Main PWB.
Board.	Tape
Wipe off using alcohol
before attaching.

FFC Spacer

!Line Processing of the Lithium Battery

Lithum Battery

Connect the Cable to the Connector CN3 of the Board. (Right angle type)

CN3	After attaching the Cushion for Lithum Battery,
	set the Lithum Battery as shown below.
	Safety Working
	Attach the Lithum Battery on the Cushion.
	Draw the Lead Wire toward the end of the Board.
	Arrange the surplus length of the Lead Wire
	as shown below.

Cushion for Lithum Battery

Attach on the IC14 (Super I/O).

Attach the white adhesive surface to the IC side.

Pass the Lead Wire through the notch of the Board.

End of the Board.

7-23