Matsushita CF-18NHHZXBM Setting the Battery Pack and the HDD Pack, Assembly of the HDD Assy

7.2.18. Setting the Battery Pack and the HDD Pack

1. Set the HDD in the HDD Case and fix it using the two	3. Open the Battery Cover and set the Battery.
Screws<A>.
	Screws<A>: DFHE5025XA

HDD Case B

Hooks

HDD FPC

HDD
Hooks	1	3
	2

Heater

<A>

<A>

HDD Case A

2. Open the HDD Cover and set the HDD Pack.

HDD Pack

Battery Pack

!Assembly of the HDD ASSY

HDD GUIDE PIN

HDD Guide

Pin Plate

Adheisive

Tape

Crosswise:

-1 to +1 mm of

the center of

the HDD Guide Pin Plate

Crosswise:

-3 to +3 mm of the center of the HDD Guide Pin Plate

Lengthwise: Avoid coming over the HDD Guide Pin Plate.

HDD Cushion Spacer HDD Damper

HDD Case B(Assy)

Set the FPC under the Damper.

		Attach under the FPC			Heater Insulation			0~0.5mm
		(between the FPC			Sheet
		and the HDD). Remove the Release Papers			Avoid coming over the
		(three) and attach them.			conductive part (metallic part)			Attach on the surface.
					of the Heater.		HDD Case
					0~1mm
							Tab	Attach on the inner
					HDD Case A
								side of the HDD
								Case A.
	0~1mm		0~1mm
					Attach the HDD Case A,
					and then connect it.
			Set the FFC to the pin of the HDD,(Four joints)
			and connect the Connector of the Heater
			to the FFC, and then attach them.					0~0.5mm
		HDD GUIDE PIN Assy		Sub material:
				PET TAPE 2
Insulation Parts			inserted into pins	(10 mm width x 3 cm)
					0~0.5mm		Shield Sheet
Cover the sensor
					Safety Working		(For GPS)
of the FPC.						Details
			Fold it back once		Match to the
					center of the
			and adjust the length.
0~0.5mm		FPC ASSY			HDD Damper.

Lengthwise:
-0.5 to +0.5 mm
ofthe center	HDD Guide
of the HDD Guide	Plate Spacer
Pin Plate

	0~5mm	Completely cover the hole of the Case.
		Press and hold the leveled part, and attach it.
Insulation Parts
		Set the Hooks of the HDD Case A inside.

FPC Assy

FPC(HDD) HDD Spacer C

0~0.5mm

0~0.5mm

	5–1mm		Ensure you can see it
				5–1mm
Insulation		Heater	from the slit space of
Parts			the HDD after assembly.		Press and
			Revision Label		hold it
					vertically,
					and screw it.

HDD Use the jig. Screw

7-33