Matsushita CF-18NHHZXBM service manual Setting the Main PCB and the Lithium Battery

7.2.10. Setting the Main PCB and the Lithium Battery

1.Set the PCMCIA Unit to Main PCB

2.Mount the HDD Guide Plate and set the Main PCB.

3.Fix the Main PCB using the four Screws <N> and the two Screws <M>.

4.Fix the Main PCB using the Screw <L>.

5.Connect the seven Cables to the corresponding Connec- tors (CN9,CN12,CN14,CN23,CN30,CN35,CN36).

6.Turn the computer over and connect the two Cables to the corresponding Connectors (CN8, CN17).

7.Connect the Cable to the Connector (CN3), and fix the Lithium Battery.

Screw <L>:DRSB2+5FKL

Screws <M>:DXYN2+J12FNL

Screws <N>:DXYN2+J18FNL

<M>		Lithium Battery
<M>	<L>
HDD Guid Plate
		Connector (CN17)
Connector (CN36) <N>		Connector (CN8)
		Connector (CN3)
<N>		Connector (CN9)
		Connector (CN14)
Connector		LAN Cable
(CN23)
Main PCB		<N>
Connector (CN35)		Connector (CN12)
Connector (CN30)		<N>
PCMCIA Unit		to Connector (CN17)
		to Connector (CN8)

!Line Processing of the Antenna Cable

Tape

Use the Tape only for	Draw it out of the cabinet.	Draw it out of the cabinet.
the position with the	Antenna Cable (Gray)
Antenna Cable.			Antenna Cable
Avoid running over	If no Gray Cable, use
			(black)
the Connector	the Brown Cable.
and the bis.

Antenna Cable

(blue)

Sub material:

PET TAPE 1

(19 mm width x 3 cm)

Sub material is not necessary if the Tape and the Cable Holder (CAP) are not used.

Cable Holder(Cap)

Details for attachment

Attach as shown above to avoid coming off.

		Screw	Screw
	Pass it between
	the bosses.
0~2mm		Heat Dissipation
		Rubber
Tape
	0~2mm Avoid running
	over the boss.	0~1mm
)	Tape	Pass it beside
		the pin.	0~1mm
	1~2mm
Safety Working

Draw it out of the cabinet.

Screw

CPU Heat Plate

Arrange the Cables, and then set it.

Draw it out of the cabinet.

Antenna Cable (white)

Heat Dissipation Rubber

Match the left end to the marking line. Fit it lengthwise in the frame.

(0 to 0.5 mm from the end of the cabinet) Check a position of power swich knob.(right)

7-22