Matsushita CF-18NHHZXBM service manual Setting the SD PCB, Assembly of SD PCB

7.2.11.Setting the SD PCB

1.Fix the SD PCB using the three Screws <h>.

2.Connect the Cable to the Connector (CN21).

Screws<h>:DXQN2+A22FNL

!Assembly of SD PCB

<h>

<h> <h>

SD PCB

Connector (CN21)

Cable Holder Sheet	Insert it into the boss
	as it comes over the Cable.

Only for the Antenna Cable Insert the surplus length under the Board.

Do not insert the Coin Battery Cable underthe Board.

	Sub material:
0~3mm	PET TAPE 2
Note for cable	(10 mm width x 3 cm)
arrangement
	Not necessary for model
	without the Antenna Cable

SD ANGLE Assy	SD Angle	0~0.5mm
0~0.5mm	Spacer 2
0~0.5mm		0~0.5mm
SD Angle	0~0.5mm	SD Angle Spacer 1
		0~0.5mm
	Screw	Screw
SD PCB		Screw

Avoid running over the positioning pin of the SD Angle.

Screw

SD ANGLE

ASSY

Avoid running	FFC
over the Cable.

Do not bend on the stiffening plate. (Bend it at 1 mm away

from the stiffening plate.)

DIMM Holder

Set the SD Board and then connect to the DIMM Connector.

*Before connecting, confirm
the Spacer is not attached	0~0.5mm
on the Main Board.
Only for model with DIMM
Release the Hooks
on the both sides
before setting the DIMM Holder.		0~0.5mm	SD Sheet

Two-sided tape

7-24