Matsushita CF-18NHHZXBM service manual Removing Inverter PCB and LCD Removing the Each Cover Unit

7.1.17. Removing Inverter PCB and LCD	7.1.19. Removing the Each Cover
Unit			<f>
Inverter Case		DC IN LID Rubber
Connector (CN2)
		USB LID Rubber
Inverter PCB
		LAN LID Rubber
Connector (CN1)		Moden/LAN LID Rubber
Connector (CN901)	HDD LID ASS’Y		Audio
TS PS2 PCB			LID Rubber
Connector (CN900)	Battery	<e> <e>	<f><f> RGB
	LID ASS’Y		LID Rubber
	<e><e>		<f> <f>
			<f><f>

Serial

LID Rubber <e>

1.Disconnect the two Cables from two Connectors (CN1, CN2).

2.Remove the Inverter Case and Inverter PCB.

3.Disconnect the two Cable from two connector (CN900, CN901).

4.Remove the TS PS2 PCB, then remove the LCD unit.

7.1.18.Removing GPRS Antenna PCB, LAN1-BT PCB, LAN2-BT PCB, Wide Area Aux PCBand Pen Holder

Wide Area￿	Pen	<b>
Aux PCB		<b> Pen Holder

LAN1-BT￿

Antenna PCB <a><a> <a>

<a>

<a>

<a>

LAN2-BT￿ Antenna PCB

<a>

GPRS ￿ <a> Antenna PCB

1.Remove the two Screws <a>.

2.Remove the GPRS Antenna PCB

3.Remove the two Screws <a>.

4.Remove the LAN1-BT PCB.

5.Remove the two Screws <a>.

6.Remove the LAN2-BT PCB.

7.Remove the two Screws <a>.

8.Remove the Wide Area Aux PCB.

9.Remove the Pen

10.Remove the two Screws <b>.

11.Remove the Pen Holder.

Screws <a> : DFHE5025XA

Screws <b> : DRHM5025YA

PCMCIA LID ASS’Y

1.Remove the 12 Screws <f>.

2.Remove the Moden/LAN LID Rubber, LAN LID Rubber, USB LID Rubber, DC IN LID Rubber, Serial LID Rubber, RGB LID Rubber and Audio LID Rubber.

3.Remove the Rear Cabinet.

(Refer to 7.1.5 Removing the Rear Cabinet)

4.Remove the six Screws <e>.

5.Remove the Battery LID ASS'Y, HDD LID ASS'Y and

PCMCIA LID ASS'Y.

Screws <e>:DRQT26+D3FKL

Screws <f>:DRHM5025YA

7-6