McCulloch 96041012400, M11577HRB instruction manual Turn assembly right-sideup

2
			16	24
				23
				26
		17		25
13	14	15		13
• Turn assembly right-side up.

• Install two 1\4” carriage bolts (13) at bottom of front bagger	• Slide rubber seal (23) to top of metal bagger handle (24).
frame (14), hand tightening lock nuts (15).	• Slide bagger handle (24) down through bagger cover and
• Feed front bagger frame (14) up through fabric loops at front	frame upper weldment holes.
of bagger.	• Slide clevis pin (25) through hole at bottom of bagger handle
• Snap bottom of front bagger frame (14) into snap feature at	and slide retainer spring (26) into hole at the end of the clevis
front of bagger bottom.	pin until it locks into place

• Slide bagger fabric loop segments at the ends of bag onto
top bagger frame tubing.			27
• Slide two 1\4” hex bolts (16) through holes at top of the front
			28
bagger frame and thread into nuts inside the tubing of top
bagger frame.
• Slide plastic clip (17) down into bagger fabric loop on right
side and snap to front bagger frame (14) 101 mm (4 inches)
from top of front bagger frame tube.
	22
			29
		30	31
22	21	• Push plastic closeout (27) back so that it snaps into place
		behind retaining ribs (28).
		• Line up holes in grass deflector (29) with bosses in bagger
		cover.
		• First install 1/4" hex bolt (30) (1/4"-15 x 1/2") into the side as
		shown.
		• Then install 1/4" hex bolt (31) (1/4"-15 x 1/2") into the top as
		shown.

•Uninstall lock nuts (21) at rear of top bagger frame and at bottom of front bagger frame and attach cross braces (22) on each side.

•Reinstall lock nuts (21) and tighten until fully seated.

26