•The attachments and ground drive can now be used. If the engine does not accept the load, restart the engine and allow it to warm up for one minute using the choke as described above.
COLD WEATHER STARTING (50 ° F and below)
8.When engine starts, slowly push choke control in until the engine begins to run smoothly. Continue to push the choke control in small steps allowing the engine to accept small changes in speed and load, until the choke control is fully in. If the engine starts to run roughly, pull the choke control out slightly for a few seconds and then continue to push the control in slowly. This may require an engine
AUTOMATIC TRANSMISSION WARM UP
Before driving the unit in cold weather,
the transmission should be warmed up as follows:
1.Be sure the tractor is on level ground.
2.Place the motion control lever in
neutral. Release the parking brake and let the clutch/brake slowly return to operating position.
3.Allow one minute for transmission to warm up. This can be done during the
engine warm up period.
•The attachments can be used during the engine
may require the choke control be pulled out slightly.
NOTE" If at a high altitude (above 3000 feet) or in cold temperatures (below 32 F) the carburetor fuel mixture may need to be adjusted for best engine performance
(see "TO ADJUST CARBURETOR" in the Service and Adjustments section of this manual).
PURGE TRANSMISSION
CAUTION: Never engage or disen- gage rreewneel lever wl_le the engine is running.
To ensure proper operation and perfor- mance, it is recommended that the
transmission be purged before operating tractor for the first time. This procedure will remove any trapped air inside the transmission which may have developed during shipping of your tractor.
IMPORTANT: Should your transmission require removal for service or replacement, it should be purged after reinstallation before operating the tractor.
1.Place tractor safely on level surface with engine off and parking brake set.
2.Disengage transmission by placing freewheel control in '_ransmission
disengaged" position (See 'q'O
TRANSPORT' in this section of manual).
3.Sitting in the tractor seat, start engine. After the engine is running, move throttle control to slow position. With motion control lever in neutral (N) position, slowly disengage clutch/ brake pedal.
4.Move motion control lever to full
forward position and hold for five (5) seconds. Move lever to full reverse
position and hold for five (5) seconds.
Repeat this procedure three (3) times. NOTE: During this step there will be no movement of drive wheels. The air is being removed from hydraulic drive system.
5.Move motion control lever to neutral
(N)position. Shutoff engine and set parking brake.
6.Engage transmission by placing freewheel control in "transmission
engaged" position (See 'q'OTRANS-
PORT' in this section of manual).
7.Sitting in the tractor seat, start engine. After the engine is running, move throttle control to half (1/2) speed. With motion control lever in neutral (N) position, slowly disengage clutch/ brake pedal.
8.Slowly move motion control lever forward, after the tractor moves
approximately five (5) feet, slowly move motion control lever to reverse
position. After the tractor moves approximately five (5) feet return the motion control lever to the neutral (N) position. Repeat this procedure with
the motion control lever three (3) times.
Your transmission is now purged and ready for normal operation.
16
