The cutting height rangeis approximately
These heightsare approximateand may vary dependinguponsoil conditions, heightof grass and types of grass being mowed.
•The averagelawnshouldbe cut to
•For bestcutting performance,grass over 6 inchesin heightshould be mowed twice. Makethe first cut relativelyhigh; the secondto desired height.
TO OPERATE MOWER
Your tractor is equipped with an operator presence sensing switch. Any attempt by the operator to leave the seat with the engine running and the attachment clutch engaged will shut off the engine.
1.Select desired height of cut.
2.Lower mower with attachment lift con- trol.
3.Start mower blades by engaging at- tachment clutch control.
TO STOP MOWER BLADES -
,_Scengage attachment clutch control. AUTION: Do not operate the mower
without either the entire grass catcher, on mowers so equipped, or the deflector shield in place.
Attachment Clutch
Attachemnt Lift
TO ADJUST GAUGEWHEELS
Gaugewheels are properly adjusted when theyare slightlyoff the groundwhen moweris at the desiredcutting height in operatingposition.Gaugewheels then keepthe deck in properpositionto help
preventscalpingin most terrainconditions. NOTE:Be sure tractor is on a flat level
surface.
1.Lowermowerandadjust mowerto desiredcutting height.
2.Removeretainerspring and clevis pin whichsecureeach gauge wheel bar.
3.Lowergauge wheels to ground. Raise gaugewheels slightlyto align holes in bracketand gauge wheel bar and insert clevis pin.Gauge wheelsshould be slightlyoff the ground.
4.Replaceretainerspring into clevis pin.
5.Be sure all gauge wheels are in the
same setting.
IMPORTANT:Be sure to readjustgauge wheels if you changethe cutting height of the mowerdeck.
Retainer
Spring
Clevis
Pin
Switch Pull Out to Lever High Position "Engage"
Position
Deflector
Shield
TO OPERATE ON HILLS
,JC_WARNING: De not drive up or down hills with slopes greater than 15 ° and do not drive across any slope. Use the slope guide provided at the back of this manual.
•Choose the slowest speed before start- ing up or down hills.
•Avoid stopping or changing speed on hills.
•If stopping is absolutely necessary, push brake pedal quickly to brake position
and engage parking brake. IMPORTANT: The motion control lever
returns to neutral (N) position when the brake pedal is depressed.
•To restart movement, slowly release parking brake and brake pedal.
•Slowly move motion control lever to slowest setting.
•Make all turns slowly.
12