Craftsman 917.27623 To Adjust Mower Cutting Height, To Operate Mower, To Stop Mower Blades

1.Lower mower and adjust mower to de-

sired cutting height(See "TO ADJUST MOWER CUTTING HEIGHT" in this

section of manual).

2.Remove retainer spring and clevis pin which secure each gauge wheel bar.

3.Lower gauge wheels to ground. Raise gauge wheels slightly to align holes in bracket and gauge wheel bar and insert clevis pin. Gauge wheels should be slightly off the ground.

4.Replace retainer spring into clevis pin.

5.Be sure all gauge wheels are in the same setting.

IMPORTANT: Be sure to readjust gauge wheels if you change the cutting height of the mower deck.

Retainer

Spring

Clevis

Pin

TO ADJUST MOWER CUTTING HEIGHT

The cutting height is controlled by turning

the height adjustment knob in desired direction.

•Turn knob clockwise (_) to raise cut- ting height.

•Turn knob counterclockwise (_-_) to lower cutting height.

The cutting height range is approximately 1-1/2" to 4-1/2". The heights are mea- sured from the ground to the blade tip with the engine not running. These heights

are approximate and may vary depending upon soil conditions, height of grass and types of grass being mowed.

•The average lawn should be cut to

approximately 2-1/2 inches during the cool season and to over 3 inches during hot months. For healthier and better looking lawns, mow often and after moderate growth.

•For best cutting performance, grass over 6 inches in height should be mowed twice. Make the first cut

relatively high; the second to desired height.

TO OPERATE MOWER

Your tractor is equipped with an operator presence sensing switch. Any attempt by the operator to leave the seat with the engine running and the attachment clutch engaged will shut off the engine. You must remain fully and centrally positioned in the seat to prevent the engine from hesitating or cutting off when operating your equip- ment on rough, rolling terrain or hills.

1.Select desired height of cut.

2.Lower mower with attachment lift con- trol.

3.Start mower blades by engaging at- tachment clutch control.

TO STOP MOWER BLADES -

disengage attachment clutch control.

_,CAUTION: Do not operate the mower

without either the entire grass catcher, on mowers so equipped, or the deflector shield in place.

	Attachment Lift Lever
Attachment Clutch	High Positi.
Switch Pull Out To	Low
"Engage"	,SPosition
	//'
	Deflector
	Shield
Push In To
"Disengage"

REVERSE OPERATION SYSTEM (ROS) Your tractor is equipped with a Reverse Operation System (ROS). Any attempt by the operator to travel in the reverse direc- tion with the attachment clutch engaged will shut off the engine unless ignition key is placed in the ROS "ON" position.

_WARNING: Backing up with the at- tachment clutch engaged while mowing is strongly discouraged. Turning the ROS "ON", to allow reverse operation with the attachment clutch engaged, should only be done when the operator decides it is necessary to reposition the machine with the attachment engaged. Do not mow in reverse unless absolutely necessary.

15