4.Install new batterywith terminalsin same positionas old battery.
5.Reinstallterminalguard.
6.First connectRED batterycableto positive(+) batteryterminalwith hex bolt and kepsnut as shown.Tighten securely.
7.ConnectBLACKgroundingcableto
8.Closeterminalaccess doors.
9.Closehood.
Hood
Headlight Wire Connector
KepsNut___ |
| |
Terminaly | _>_ | exBolt |
Access_ | " | |
Door . | Positive(Red) | |
Guard | _ | "Negative(Black) |
| ............ | Cable |
TO REPLACE HEADLIGHT BULB
1.Raise hood.
2.Pull bulb holder out of the hole in the backside of the grill.
3.Replace bulb in holder and push bulb holder securely back into the hole in
the backside of the grill.
4.Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause
your tractor to run poorly, stop running, or prevent it from starting.
• Check wiring. See electrical wiring diagram in the Repair Parts section.
TO REPLACE FUSE
Replace with 30 amp
ENGINE
Maintenance, repair, or replacement of the emission control devices and systems, which are being done at the customers ex- pense, may be performed by any
engine repair establishment or individual. Warranty repairs must be performed by an
authorized engine manufacturer's service outlet.
TO ADJUST THROTTLE CONTROL CABLE
The throttle control has been preset at the factory and adjustment should not be nec- essary. Check adjustment as described below before loosening cable. If adjust- ment is necessary, proceed as follows:
1.With engine not running, move throttle control lever to fast position.
2.Check that speed control lever is against stop screw. If it is not, loosen casing clamp screw and pull throttle cable until lever is against screw. Tighten clamp screw securely.
Idle Fuel Adjusting | Idle Speed | |
Needle (If Equipped) | ||
Ad usting Screw | ||
|
TO REMOVE HOOD AND GRILL AS-
SEMBLY
1.Raise hood.
2.Unsnap headlight wire connector.
3.Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.
4.When replacing hood, be sure to re- connect the headlight wire connector.
Stop
Screw
27 Clamp Screw
Throttle
Control
Cable
Choke
Control