•Slide blade on to an unthreaded portion of the steel bolt or pin and hold the bolt or pin parallel with the ground. If blade is balanced, it should remain in a horizontal position. If either end of the blade moves downward, sharpen the heavy end until the blade is balanced.
Center Holej /
or Pin _ade
BATTERY
Your tractor has a battery charging system which is sufficient for normal use. How-
ever, periodic charging of the battery with an automotive charger will extend its life.
•Keep battery and terminals clean.
•Keep battery bolts tight.
•Keep small vent holes open.
•Recharge at
your tractor is maintenance free. Do not
attempt to open or remove caps or covers. Adding or checking level of electrolyte is
not necessary.
TO CLEAN BATTERY AND TERMINALS Corrosion and dirt on the battery and termi- nals can cause the battery to "leak" power.
1.Remove terminal guard.
2.Disconnect BLACK battery cable first then RED battery cable and remove battery from tractor.
3.Rinse the battery with plain water and
dry.
4.Clean terminals and battery cable ends with wire brush until bright.
5.Coat terminals with grease or petro- leum jelly.
6.Reinstall battery (See "REPLACING BATTERY" in the SERVICE AND AD-
JUSTMENTS section of this manual).
TRANSAXLE COOLING
Keep transaxle free from
CHECKTRANSAXLE OIL LEVEL
1.Block up rear axle securely.
2.Remove left rear wheel by removing hub bolts.
3.Remove filler plug from transaxle. Oil level must be even with plug threads.
If necessary, fill with SAE 30 motor oil,
API
4.Reassemble wheel to hub.
Check
Replace belts if they begin to slip from wear.
ENGINE
LUBRICATION
Only use high quality detergent oil rated with API service classification
Select the oil's SAE viscosity grade according to your expected operating temperature.
SAE VISCOSITY GRADES
F | _20 | 0 | 30 32 40 | 60 | 80 | 100 |
c | ; | 1'0 _0 | 10 | 4; |
TEMPERATURE RANGE ANTICIPATED BEFORE NEXT OIL CHANGE
oil vJsc cha_t4 ÷
Change the oil after every 50 hours of op- eration or at least once a year if the tractor
is not used for 50 hours in one year. Check the crankcase oil level before start-
ing the engine and after each eight (8) hours of operation.
TO CHANGE ENGINE OIL
Determine temperature range expected before oil change. All oil must meet API service classification
•Be sure tractor is on level surface.
•Oil will drain more freely when warm.
•Catch oil in a suitable container.
1.Remove oil fill cap/dipstick. Be careful not to allow dirt to enter the engine
when changing oil.
2.Install the drain tube onto the fitting.
3.Open drain valve by using a 7/16"
(11 mm) wrench turning counterclock- wise.
Oil Drain Valve
To Open
To Close
Drain Tube
o | _ | Transaxle Filler | . | After oil has drained completely, close | |||||
o | o | Plug |
|
|
|
|
|
| |
| the drain valve turning clockwise. Use | ||||||||
|
|
|
| ||||||
|
|
|
| the 7/16" (11 mm)wrench | to | apply | |||
|
|
|
| a small | amount | of | torque | to | keep it |
|
| 20 |
| closed. | Do not | over | tighten. |
|