REPLACING BATTERY
_WARNING: Do not short battery terminals
by allowing a wrench or any other object to contact both terminals at the same time.
Before connecting battery, remove metal
bracelets, wristwatch bands, rings, etc. Positive terminal must be connected first to
prevent sparking from accidental grounding.
1.Lift hood to raised position.
2.Disconnect BLACKbatterycable (A) then RED battery cable and carefully remove battery from tractor.
3.Install new battery with terminals in same position as old battery.
4.First connect RED battery cable (B) to positive (+) battery terminal with hex bolt and keps nut as shown. Tighten securely.
Slide terminal cover (C) over terminal.
5.Connect BLACKgrounding cableto neg- ative
6.Close hood.
TO REMOVE HOOD & GRILL ASSEMBLY
1.Raise hood.
2.Unsnap headlight wire connector.
3.Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.
4.When replacing hood, be sure to recon- nect the headlight wire connector.
Hood
Headlight Wire
Connector
(_ (Black)Negative Cable
ENGINE
Maintenance, repair, or replacement of the emission control devices and systems, which are being done at the customers expense, may be performed by any
repair establishment or individual. Warranty repairs must be performed by an authorized engine manufacturer's service outlet.
Positive
(Red) Cable
TO REPLACE HEADLIGHT BULB
1.Raise hood.
2.Remove bulb holderfrom the hole in the backside of the grill.
3.Replace bulb in holder and install bulb holder securely back into the hole in the backside of the grill.
4.Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.
•Check wiring. See electrical wiring dia-
gram in the Repair Parts section.
TO REPLACE FUSE
Replace with 30 amp
the dash.
CARBURETOR
If your engine does not operate properly due to suspected carburetor problems, take your tractor to a Sears or other qualified service center for repair and/or adjustment.
High speed stop is factory adjusted. Do not adjust - damage may result.
IMPORTANT: Never tamper with the engine governor, which is factory set for proper
engine speed. Overspeeding the engine above the factory high speed setting can be dangerous. If you thinkthe
28