Your new tractor has been assembled at the factory with exception of those parts left unassembledfor shipping purposes. To ensure safe and proper operationof your tractor all parts and hardware you assemble must be tightened securely. Use the correct tools as necessaryto insure propertightness.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly easier. Standard wrench sizes are listed.
(2) | 7/16" | wrenches | Utility knife |
(1) | 1/2" | wrench | Tire pressure gauge |
(1) | 3/4" | wrench | Pliers |
(1) | 3/4" | socket w/drive | ratchet |
When right or left hand is mentioned in this manual, itmeans when you are inthe operating position (seated behind the steering wheel).
TO REMOVE TRACTOR FROM
CARTON
UNPACK CARTON
•Remove all accessible loose parts and parts cartons from carton.
•Cut along dotted lines on all four pan- els of carton. Remove end panels and lay side panels flat.
Remove mower and packing materials.
Check for any additional loose parts or cartons and remove.
BEFORE REMOVING TRACTOR
FROM SKiD
CHECK BATTERY
1. Lift hood to raised position.
NOTE: If this battery is put into service after month and year indicated on label (label is located between terminals) charge battery for minimum of one hour at
ADJUST SEAT
1.Sit in seat.
2.Lift up adjustment lever (A) and slide seat until a comfortable position is reached which allows you to press
clutch/brake pedal all the way down.
3.Release lever to lock seat in position.
NOTE: You may now roll your tractor off
the skid. Follow the appropriate instruction below to remove the tractor from the skid.
,_WARNING: Before starting, read, understand and follow all instructions in the
Operation section of this manual. Be sure tractor is in a
the area in front of tractor is clear of other people and objects.
TO ROLL TRACTOR OFF SKiD
(See Operation section for location
and function of controls)
1.Raise attachment lift lever to its highest position.
2.Release parking brake by depressing clutch/brake pedal.
3.Place gearshift lever in neutral position.
4.Roll tractor forward off skid.
ASSEMBLE FRONT WHEEL TO
MOWER
1.Using shoulder bolt, washer and Iocknut from parts bag, assemble front wheel to mower as shown. Tighten securely.
8
