Yournew tiller has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tiller all parts and hardware you assemble must be tightened securely. Use the correct tools
as necessary to insure | proper | tightness. |
|
TOOLS REQUIRED | FOR | ASSEMBLY | FRONT |
|
A socket wrench set will make assembly easier. Standard wrench sizes are listed.
(t)Utility knife
(1) Wire cutter
(1) Tire pressure gauge | LEFT | RIGHT | |
(1) | Screwdriver |
|
|
(1) | Pair of pliers |
| L1 |
(1) | 9/16" wrench |
| |
OPERATOR'S POSITION |
| ||
When right or left hand is mentioned in |
| ||
this manual, it means when you are in |
| ||
the operating position (standing behind |
| ||
tiller handles). |
| ||
OPERATOR'S
POSITION
CONTENTS OF HARDWARE PACK
(2) Handle Locks |
| (1) Center | Locknut |
(1) Carriage | Bolt |
| |
|
| ||
|
| (1) Cable Clip | |
|
|
| |
I |
|
|
|
(2) Hairpin Clips |
|
|
|
|
| (1) | Pivot Bolt |
|
| ||
(1)Flat Washer 13/32 x I x 11 Ga.
Extra Shear Pins & Clips | (1) Handle Lock Lever |
r
