Craftsman 917.421264, 486.421264 manual Tools, Required For Assembly, See Figure

TOOLS	REQUIRED FOR ASSEMBLY	STEP 2: (SEE FIGURE 2)
		*	insert 1/4 x 1-1/4" hex		bolt through one of the springs.
(2)	7/16" Wrenches	*	Assemble	1/4 x 1-1/4"	hex bolt onto the bumper using
(2)	9/16" Wrenches		two 1/4-20	hex nuts (SIMS) with end of bolt extending
(1)	3/4" Wrench		slightly through outside		nut.
		*	Repeat for spring on other side.

CAUTION! Muffler is hot! Allow engine to cool down before proceeding with bumper installation.

STEP 1: (SEE FIGURE 1)

•Slide the ends of the latch into the slots located on the bottom of the bumper.

Push the front of the latch down past plastic shroud of bumper. Latch will be under the shroud and should appear as shown in figure 3 when assembled correctly'.

Attach one spring onto the rod on each side of the latch.

1/4" HEX NUT (SIMS)

114 X 1-114"

HEX BOLT

SPRING

FIGURE 2

STEP 3: (SEE FIGURE 3)

Assemble a 3/8 x 1" hex bolt, 3/8" washer, frame brace and 3/8" lock nut to the rear hole of the bumper.

LATCH

_SPRING

318 X 1"

HEX BOLT

318" WASHER /

FIGURE 1

\ /

318" LOCK NUT FRAME

BRACE

FIGURE	3
4	Call 1-866-576-8388 for missing parts or assembly help
	DO NOT RETURN TO STORE