7.Place assembled gun and wand on pressure washer holder.
Gun/Wand
Holder
Cord
Wire Bracket
8.Place pull cord into the wire bracket holder.
•Pull the cord under the wire bracket to the right of the wire loop.
•Lift the pull cord handle up and slide the cord to the left, sliding the cord into the wire loop.
•Next slide handle behind the wire bracket to the left of the wire loop.
•Engine recoil will pull the cord into its final position.
Checklist
Before going any further please review the following:
•Be sure you have completed assembly instruc- tions.
•Double check all fittings to be sure they are tight.
IMPORTANT: Before any attempt to start your pressure washer be sure to check engine oil (See Engine Oil on page 8.)
OPERATION
Know Your High Pressure Washer
Read this Owner’s Manual and Safety Rules before operation of your High Pressure Washer Compare this illustration with our pressure washer to familiarize yourself with the location of various controls and adjustments. Save this manual for future reference.
PUMP- Develops high pressure.
ENGINE RUN/STOP SWITCH- Sets engine in starting mode for recoil starter — Stops running engine.
RECOIL STARTER- Used for starting the engine manually.
SPRAY GUN ASSEMBLY (Contains Gun and Wand)- Controls the application of water onto cleaning surface with trigger device.
OIL FILL- Port where engine oil is poured.
GAS TANK/CAP- Cap is removed and unleaded gasoline is poured.
HIGH PRESSURE OUTLET- Connection for high pressure hose.
CHOKE- Used to start a cold engine.
SPRAY GUN
ASSEMBLY
HIGH PRESSURE
HOSE
GAS
TANK/
CAP
CHOKE
ENGINE
STOP/
START
HANDLE
RECOIL
STARTER
OIL FILL
PUMP
HIGH
PRESSURE
OUTLET
WATER INLET
CONNECTION
D20590
