How To Use Your Pressure Washer
Adjusting Chemical Flow
•Turn the knob on the high pressure soap wand to adjust the soap flow. Turn knob counterclockwise for more soap (+) and clockwise for less soap
Soap Knob
+ more soap
- less soap
Adjusting Fan Spray
•The nozzle at the end of the high pressure soap wand can be rotated to change the high pressure spray pattern from a narrow jet to a 50O fan shape, as shown.
50° fan spray
narrow jet
stream
Using Soaps/Chemicals
IMPORTANT: Use soaps and chemicals that are designed specifically for use with pressure washers.
To apply soaps/chemicals follow these steps:
•Prepare the soap/chemical as required for your job.
•Press one end of the clear soap hose (supplied) onto the barb fitting on the high pressure soap wand.
•Place the other end of the soap hose into the container of pressure washer approved cleaning fluid. (soap/chemicals and container not included).
Barb Fitting
Approved
Cleaning
Fluid
•Start the pressure washer as outlined in the “To Start Your Pressure Washer” paragraph on page 9.
WARNING: Stand on a stable surface and grip gun/wand firmly with both hands. Expect the gun to kick when triggered.
•Depress the trigger on the gun to begin spraying. Release trigger to stop spraying.
CAUTION: DO NOT stop spraying water for more than two minutes at a time. Pump operates in bypass mode when spray gun trigger is not pressed. If pump is left in bypass mode for more than two minutes internal components of the pump can be damaged.
•Adjust the fan spray and soap flow. See Adjusting Chemical Flow and Adjusting Fan Spray.
WARNING: Risk of injection or injury to person. DO NOT direct discharge stream toward persons.
•Apply soap/chemicals to dry surface, starting from the bottom and working up.
•Allow the soap/chemicals to soak in between
•When rinsing on high pressure, start at lower portion of area to be washed and work upward, using long, even, overlapping strokes.
•After use of chemical, spray clean water through soap hose.
D20590 | |
|
