8.Turn fuel valve to the ON position, 1/4 turn counterclockwise.
9.Move the choke control lever to
the CHOKE ON 
position and
the throttle control to the FAST
position. NOTE: No choke is needed to start a warm engine.
Choke
Control 
Throttle
Control
Fuel Valve Knob
10.Pull starter grip slowly until you feel resistance, then pull briskly. Return starter grip gently. Pull rope with a rapid full arm stroke. Let rope rewind slowly. Repeat if necessary.
If the engine does not start after two pulls, pull the trigger to relieve the
pressure.
11.If the choke was used to start the engine, move the choke lever to the OFF position.
12.Depress trigger on gun to start water flow. NOTE: Stand on a stable surface and grip gun/spray wand firmly with both hands. Expect the gun to kick back when triggered.
13.Release trigger to stop water flow.
14.Adjust nozzle spray for the task being performed. See How To Use Spray Wand instructions in this section.
DO NOT let hoses come in contact with
very hot engine muffler during or immediately after use of your pressure washer.
MAINTENANCE
When performing maintenance, you may be exposed to hot surfaces, water pressure, or moving parts that can cause
serious injury or death!
Before performing any maintenance or repair, disconnect spark plug wire, let engine cool and release all water pressure. The engine contains flammable fuel. DO NOT smoke or work near open flames while performing maintenance.
To ensure efficient operation and longer life of your pressure washer, a routine maintenance schedule should be prepared and followed. If the pressure washer is used in unusual conditions, such as
13- ENG | A04549 |
