8.Pull engine starter rope slowly several times until antifreeze comes out of high pressure hose connection of pump.
9.Remove short hose from water inlet of pump.
10. Reconnect spark plug wire.
*Windshield washer fluid may also be used
TROUBLESHOOTING GUIDE
PROBLEM |
| CAUSE |
| CORRECTION | |
|
|
|
|
| |
Engine will not | 1. | No fuel. | 1. | Add Fuel. | |
start | 2. | Pressure builds up after | 2. | Squeeze gun trigger to | |
| |||||
|
| two pulls on the recoil |
| relieve pressure. | |
|
| starter or after initial use. |
|
| |
| 3. | Not choked. | 3. | Choke engine, place engine | |
|
|
|
| in the choke position. | |
| 4. | Spark plug wire not | 4. | Attach spark plug wire. | |
|
| attached. |
|
| |
| 5. | Choke lever in the | 5. | Move choke to the "No | |
|
| "Choke" position on a |
| Choke" position. | |
|
| "hot" engine or an engine |
|
| |
|
| that has been exposed to |
|
| |
|
| thermal heat for a long |
|
| |
|
| period of time. |
|
| |
| 6. | Fuel valve closed | 6. | Move the fuel valve knob to | |
|
|
|
| the "Open" position. | |
|
|
|
|
| |
No or low | 1. | Wand not in high | 1. | See How to Use Spray | |
pressure | |||||
| pressure. |
| Wand paragraph in the | ||
(initial use) |
|
|
| Operation Section. | |
|
|
|
| ||
| 2. | Low water supply. | 2. | Water supply must be at | |
|
|
|
| least 5 GPM @ 20 PSI. | |
| 3. | Leak at high pressure | 3. | Tighten. Apply sealant tape | |
|
| hose fitting. |
| if necessary. | |
| 4. | Nozzle obstructed. | 4. | See Spray Wand | |
|
|
|
| paragraph in the | |
|
|
|
| Maintenance section for | |
|
|
|
| the correct procedure. | |
| 5. | Water filter screen | 5. | Remove and clean filter. | |
|
| clogged. |
|
| |
|
|
|
|
|
A04549 | 18- ENG |
