Craftsman D30333, 919.672190 owner manual Dual Tank Cleaning System

7.Add *RV antifreeze to hose as shown.

8.Pull engine starter rope slowly several times until antifreeze comes out of high pressure hose connection of pump.

9.Remove short hose from water inlet of pump.

10.Reconnect spark plug wire.

*Windshield washer fluid may also be used

DUAL TANK CLEANING SYSTEM

1.Turn control valve knob to the down (off) position.

Control Valve Knob

2.Remove cleaning solution hose at chemical injector and pull it over the axle and to the rear of the unit.

3.Place end of cleaning solution hose into a suitable container to drain cleaning solution.

4.Turn control valve toward tank to be drained.

5.Repeat steps 3-4 to drain second tank.

6.Turn control valve knob to the down (off) position.

7.Fill tanks with clean water.

8.Turn valve toward tank and drain water from tank. Repeat on second tank. NOTE: This will rinse cleaning solution tanks.

9.Route the cleaning solution hose over the axle and reconnect cleaning solution hose to chemical injector for future use.

Axle

Hose

D30333 20- ENG