3.Turn the fuel valve to the OFF position if engine will not be restarted soon.
4.Turn water source off.
5.Pull trigger on spray gun to relieve any water pressure in hose or spray gun.
6.See Storage section in this manual for proper storage procedures. NOTE: Cleaning solution must be removed from cleaning solution tanks if storing unit longer than 30 days, see Storage section for correct procedure.
BEFORE STARTING
Read and understand all Important Safety Instructions in the front of this manual and the following Cautions and Warnings before starting the pressure washer.
•Never fill fuel tank completely. Fill tank to 1/2" below bottom of filler neck to provide space for fuel expansion. Wipe any fuel spillage from engine and equipment before starting engine.
•Never fill fuel tank indoors. Never fill fuel tank when engine is running or hot. Do not smoke when filling fuel tank.
•Never run engine indoors or in enclosed, poorly ventilated areas. Engine exhaust contains carbon monoxide, an odorless and deadly gas.
•Never turn water supply off while pressure washer engine is running or damage to pump will result.
•DO NOT use hot water, use cold water only.
•DO NOT stop spraying water for more than two minutes at a time.
1.In a well ventilated outdoor area add fresh, high quality, unleaded gasoline with a pump octane rating of 86 or higher. Do not overfill. Wipe up spilled fuel before starting the engine.
2.Remove filler cap/dipstick and add engine oil (supplied) to engine. NOTE: There will be a slight amount of oil in the engine from factory testing. Always check oil level before each
Filler cap/dipstick
3.Verify the filter screen is in water inlet of pump. NOTE: Cone side faces out.
Filter Screen
4.Connect high pressure hose to pump outlet.
5.Connect water source to pump inlet.
NOTE: Water source must provide a minimum of 5 gallons per minute at 20 p.s.i.
High
WaterPressure
SourceHose
D30333 | 14- ENG |
