![](/images/new-backgrounds/1101760/10176019x1.webp)
RECEPTACLES
Your generator is equipped with
The unit is equipped with a
Battery Installation
To obtain electric start capability, you must install a (12 volt – 45 A.H.) battery. The battery should be properly serviced and fully charged prior to installation.
Install the battery as follows:
•Place battery in rack with terminals facing towards generator head.
•Place battery bracket over battery as shown (oppo- site battery terminals).
FULL POWER SWITCH
Your Craftsman generator has a full power switch on the control panel. This switch has two positions: 120 VOLT ONLY, and 120/240 VOLT.
120 Position
When placed in the 120 position, (shown below) every re- ceptacle on the panel will be converted to a 120 volt recep- tacle.
120V 120/240V
120/240 Position
When in the 120/240 position, (shown below) only half of the 5800 watts can be received when using the
120V 120/240V
IMPORTANT: Do not move the full power switch while powering electrical equipment. Unplug all items before moving the switch. Failure to do so can damage the switch.
•Connect black battery cable from battery post indicated with NEGATIVE
•Connect red battery cable from battery post indi- cated with POSITIVE, (+) to right post on starter solenoid.
solenoid | (+) Positive |
Battery Cable
Connection
GENERATOR CAPACITY
Exceeding the rated capacity of your generator can result in serious damage to your generator and connected electrical devices. You should observe the following to prevent overloading the unit:
•Starting and running wattage requirements must be calculated to match your generator wattage capacity.
10 — ENG